First of all I installed some magnets on the wings (so they can be detachable)

Then i took out some foam and glued some Velcro to make space for my 2 5000mah batteries

 And finally the Gopro pan/tilt mount :)

Electronics arrived today :)

Glued the back wing and shaped the foam for the rudder ( Is there any other way to mount the servo rather than gluing it to the foam?)

Installed the motor , which is a turnigy 35-42B 1250Kv, mount needs some hot glue

Then the ailerons , all servos are the 1800A

That's all for now , if u have any advice or comments please let me know:)

So my kit from HK arrived yesterday and I should note that this is my first build ( If you see terrible mistakes don't hesitate  to shout;))

Soldered the carbon rod using some super glue. I installed those holders just in case even though most probably am gonna put the elevator end radder servos on the wing itself

Glued the 2 wooden parts with white glue , then using superglue to the foam and around it some epoxy just to make sure ( Did I used too much glue ?:P)

Here is a close up

Thats all for today, also some question :) :

1) is there an easy way to aline the back wing (elevator) with the hole stracture in order to be 90 degrees with the fuselage?

2) shall i use superglue for epp to epp or buy some CA?