Gender
Female
About
Location
Singapore
About Me:
I am a polytechnic student and I am doing the UAV project.
Please tell us a bit about your UAV interest
I hope I can learn more knowledge from this website.
Hometown:
Johor Bahru
Activity Feed
"I noticed a problem again. I have tested my flight, (using stable mode), my quadrotor even cannot take off. It always flip over to the sides..... (sometimes left and sometimes is right)I am wondering whether changing a PID value will help in my…"
Firstly, I have a quastion about the arming of the motor. For my esc, I need to push my throttle to lower right, then on the safety switch of my esc(beep once for each esc), push the throttle to maximum, then it will beep once again, after that push…
I was having problem on my quadrotor project.Before I had connected the receiver, when I connected the battery with my 4 esc, i can observe that the motor was moving little bit...After I have connect my receiver, when I use the configurator for…
"Have any ideas about adding the LED...
From the webpage, I saw one page that is about the LED on the frame but it is under construction....
Is it similar to the thing that I want to do on my quadrotor?"
From the webpage, I saw one page that is about the LED on the frame but it is under construction....
Is it similar to the thing that I want to do on my quadrotor?"
Currently I am doing on the arducopter and I have encountered some problems about the programming part. Firstly, how do I vary the PID values for my quadrotor?I have found certain lines in the programming, is it changing this to do? (I am using…
"Is it the same as arducopter?
Therefore, I just need to connect the battery to my 4 ESC and the APM will be powered?"
Therefore, I just need to connect the battery to my 4 ESC and the APM will be powered?"
Currently I am doing on the quadcopter project.Our goal is to have a quadrotor that is less than 1kg.What is the power connection for the ardupilot mega chip? Do I need to use additional battery to power on the chip(but it will increase the weight).…
