About

Gender

Male


Location

WA


About Me:

newbie


Please tell us a bit about your UAV interest

newbie


Hometown:

Aus


Activity Feed

andy replied to andy's discussion Pixhawk GPS drifiting around
"Hi Nuno, I tested in Australia....I had reported this issue to 3dr and they found out it is GPS issue....did RMA and now waiting my GPS from US"
Aug 19, 2014
andy replied to andy's discussion Pixhawk GPS drifiting around
"Does anyone having same issue?"
Aug 6, 2014
andy posted a discussion
When i have my quad on the ground and connect to mission planner via telemetry radio, i saw in flight data  showing my drone moving around even my quad was actually on the ground.  Then i checked how many sat is actually connected, it was 7.  When i…
Aug 3, 2014
andy replied to andy's discussion Quad unstable to take off
"in Mission Planner show X type"
Aug 1, 2014
andy replied to andy's discussion Quad unstable to take off
"I will try that tonight"
Aug 1, 2014
andy replied to andy's discussion Quad unstable to take off
"Hi Matt,

* Do the motors all seem to spin at about the same rate after you arm the copter prior to take off?
- all other 3 motors seem having same rate but except motor 1.

* Have you checked all of your joins/soldering to ensure there's nothing…"
Aug 1, 2014
andy replied to andy's discussion Quad unstable to take off
"Hi Graham,
 
Motors 1 and 4 does not resist when i tilt right then i did ESC calibration one by one.  After this all, it resist all direction, but motor 1 seem like spinning different speed as others 3 motors.  When i increase throttle to about 40%,…"
Jul 31, 2014
andy replied to andy's discussion Quad unstable to take off
"any one have any idea?"
Jul 31, 2014
andy posted a discussion
Hi, I am new to Quad world. Recently building one new quad it become unstable when i installed propellers and ready to take off. I am not dare to take off with this condition, so i tried to hold my quad in the air and try almost half throttle…
Jul 29, 2014
andy replied to andy's discussion Individual Power to Pixhawk
"Anyone know whether it is possible?"
Jun 27, 2014
andy posted a discussion
Is anyone power up Pixhawk controller with separate battery? If so, which battery should i use?
Jun 27, 2014
andy commented on Andy Jensen's blog post 3DR International Shipping Update
"Just checked in other discussion, Chris mention that "we did announce at DroneCon that exports to 44 countries (including Europe, Australia and most others we usually serve) will resume this week.  That's great news and having now gone through this…"
Jun 26, 2014
andy replied to Pierre Gibouin's discussion 3DRobotics temporarily stops shipments outside of US and Canada
"Hi Chris,

Is that mean i can order it from 3DR store and ship to Australia?"
Jun 25, 2014