"Hi, thanks to the team of developers, now we have 3.1.3!
I really did not experience any issues since ancient 3.0-rc5 and dozens of flighs but there is a flyway video below I simply can not share. Enjoy. https://www.youtube.com/watch?v=l83T7ToRn1w"
"That just completes one cycle. And there is design improvement every time new board created.
Truth is that even with that lucrative price I would not buy APM anymore. Bought my last one 8 month ago, $50 second hand. It is STM32/PX4 time already."
"Ok I think GPS (Loiter mode) makes my H4 approach ground at sub optimal angle and speed.
Happened on -rcX October 31 (rainy afternoon) and again today when filming icing.
Arducopter 3.1Stab mode and Alt Hold were just fine.The moment I switch to…"
"Is there a way to fly in ACRO mode with 60 deg pitch/roll limit removed? I would like to be able to do flips by pulling on the sticks. I am aware of the FLIP flight mode (toggle) which just does automatic flip.
"Randy,
I was flying 3.0-rc5. Switching from descend in ALT-HOLD or LOITER to STAB makes copter free fall immediately. Apparently full throttle does not save if from 40 meter altitude and I hit ground. That hurts. Any parameters I can adjust to…"
"Have a "RTL motor stop thing" hitting my Y6 twice in the air. Yes it took it from +40m altitude to -9m in two kicks. Yes, negative alt ;)
Details in video below,1080p is available. For some reason MP lost connection and does no show useable log. …"
"I see yaw_rate P default change to 0.20 (was 0.25).. Moving my post from 2.9.1 thread to this one as Y6 actually was flying on 2.9.1b. But yaw performance was the same (slow) on 2.9.1 as well.
I tried increasing rate YAW I and P with no avail.…"
"Well, I am using 2.9.1... was tuning PIDs flying in my basement trying to get it right for rctimer 4215(3507) 650KV motors on 4S 12x3.8 props on Y6. After like 20 minutes of tuning (i use 433Mhz telemetry/radio) disaster happened. When hoovering 4…"