Gender
Male
About
Location
Ankara
About Me:
I am a student of electronics and communications engineering.
Please tell us a bit about your UAV interest
helicopter and quadrotor are my interests.
Hometown:
Turkey
Activity Feed
himy first issue about magnetometer. I soldered diydrones magnetometer to imu board like manual but I want to disable it now. connection has been dropped when I tryed the configurator disable button. Am I change the config code ? I used ardupirates…
I took last month ublox GPS and HMC5843 magnetometer. I solder the magnetometer.I connected the GPS. I changed the code. and installed.I did transmitter configirationbut now arducopter does not work. engines does not work. I tried to transmitter…
"I did not move right stick but it move right-left or back and forth slowly. I expected not movement ."
Hi everyoneAfter a few problems,it is now flying,but i cannot stabilize it.Do you think it's because of me being inexperienced or it's the quadrotor?I'm not using magnetometer,maybe it's because of that?or which settings should i change?i want a…
Hi I want to synchronize the rc transmitter with arducopter configurator 1. attemptmotors, lipo, esc and usb are all tied (propellers take off) i am opening arducopter Configurator. Cross section of the Transmitter Adjustment. I move rc sticks like…
"I thought both of them able to use it. I will try ArduCopter Configurator tomorrow. Thank you for reply"
I upload Arducopter_alpha_RC1 and then I try configure. but I get this message " Flight Control Software version 2.0 or higher is required to all features of the Configurator to work properly."if I accept and continue I can't configure transmitter…
hi first of all ı am sorry for my bad englishı really want to make a simple quadrotor but ı cant figure out where can ı start. mechanical parts and make model are easy for me. ı designed a model with use solidworks cad program. ı am searching net…
