How to clean the 850Kv Jdrone Motors?
I crash my quad-copter into a muddy area and some mud have gotten into the motor. Is it possible to open up the motor and get the mud out? Thanks
Read more…harin sanghirun's Discussions (5)
Sort by
Can't Change Flight Mode
The quad won't change to any other mode other than stabilize and Alt Hold.
I have my flight mode set up like this
Mode 1 - Land
Mode 2 - Stabilize
Mode 3 - Stabilize
Mode 4 - Loiter
Mode 5 - Alt Hold
Mode 6 - Stabilize
When I turn my quad on it will be on mo
Read more…Need help installing voltage detector to APM1
I was recently given Turnigy voltage detector, but was unsure about how to install it on the apm1 board. I checked the wiki, which has a instruction for the AttoPilot sensor, which has 3 wires, while this one only have 2 (red and black).
Do I just sol
Read more…Turnigy 9x signal issue
The signal range on the ch.2 (pitch) of my turnigy 9x was dramatically reduce from about 1000-1800 to 1600-1800. While other channels remain at about 1000-1800. Does anybody know what could possibly cause this?
Notes.
- Yesterday I opened up the tx to c
Radio Calibration Problem Turnigy 9X
First of all I have to say that I'm completely new to the RC world.
Today I just finish assembling an quadcopter kit from jDrones. I loaded the latest firmware onto the APM 1 and everything seems to be working fine, but when I try to setup for the fir
Read more…