Gender
Male
About
Location
Buckinghamshire, England
About Me:
just interested in auto control of gliders and programing
Please tell us a bit about your UAV interest
I fly full size and model gliders and heli's and would like to play around with automated control
Hometown:
aylesbury
Activity Feed
"Hi Todd,
No, I don't understand why explaining this was so hard or what harm could have been done it's a simple question.
Regards John"
No, I don't understand why explaining this was so hard or what harm could have been done it's a simple question.
Regards John"
"Hi again,
Tests on the APM2 I've got show at least that:-
1) The board complete with xbee starts at 4.41V and at 5.63V.
2) At these voltages it will run for at least an hour.
3) The GPS locks and stays that way.
4) That after the hour there is no…"
Tests on the APM2 I've got show at least that:-
1) The board complete with xbee starts at 4.41V and at 5.63V.
2) At these voltages it will run for at least an hour.
3) The GPS locks and stays that way.
4) That after the hour there is no…"
Hi There,I'm sure I've just missed this, but what are the Min and Max voltages for APM2 boards?I've seen 5V in loads of places. I'd just like to know so that I can provide a suitable voltage.Many thanksJohn Fletcher
"Hi There,
Well, the solution goes like this :-
First, installed the power is normally applied to the 5V rail on the OUTPUT side of the APM. APM1 does not care which side it's powered from and works even if the receiver is powered and the servos…"
Well, the solution goes like this :-
First, installed the power is normally applied to the 5V rail on the OUTPUT side of the APM. APM1 does not care which side it's powered from and works even if the receiver is powered and the servos…"
"Well, Well!!
For 2.4 XBEE Pro S2B on Sparkfun adaptors only.
After searching for hours and hours the soloution seems to bee :-
Always read the settings before you change something so that only the bits you want are changed.
Always start the…"
For 2.4 XBEE Pro S2B on Sparkfun adaptors only.
After searching for hours and hours the soloution seems to bee :-
Always read the settings before you change something so that only the bits you want are changed.
Always start the…"
"Hi Jeff,
I have had little success with S2B, but I have had some!
Here's the score so far,
Changing the config with digi's utility to XB24-B and using zigbee AT co-ordinator and zigbee AT router/end device with pan id set to a useful value puting…"
I have had little success with S2B, but I have had some!
Here's the score so far,
Changing the config with digi's utility to XB24-B and using zigbee AT co-ordinator and zigbee AT router/end device with pan id set to a useful value puting…"
Hi Flolks,First the kit :-Recently bought APM 1, IMU to match, compass and ublox 5 in an already flying Taylorcraft 450 by E-Flight.Now the questions,First although I'm getting most of the things I expect, yawing the airframe left and right does not…
