About

Gender

Male


Location

Bangkok


Please tell us a bit about your UAV interest

I am interrested about diy UAV and I plan to build my own one.


Hometown:

Bangkok


Blog Posts

Activity Feed

mrBert posted a discussion
Pixhawk burned dueto servo stuck
Hi,I have newbie using pixhawk. My pixhawk was burned out due to one of my servo for camera trigger (rc10) was sucked on the camera while booting.I have open and have a look inside pixhawk board and I found two spots that not normal on the board,…
See More
Feb 28, 2015
mrBert commented on Ritchie's photo
"hi Ritchie, 

I would like to trigger my camera via servo with APM2.5 too, i have connected to CH7 on my APM but not thing happen. Can you tell me how to set up this please ......

Thanks,"
Dec 3, 2014
mrBert commented on Ron Justin's blog post FLIR Lepton compact thermal imager camera core
"Cool!"
Sep 22, 2014
mrBert replied to Vaibhav Chauhan's discussion Trigger camera shutter by servo at waypoint IF the Remote has a channel set to high
"Hi Vaibhav,
Did you solved this triggering setup yet? I am also got this problem too..."
Mar 3, 2014
mrBert left a comment for mrBert
"Did you checked on the error in terminal command? If some thing wrong with the compass and based on your voltage measurement is over 5.xxV that is might be the IC regulator was damaged.

Did you use your APM to drive your servos directly? If yes,…"
Mar 2, 2014
mrBert replied to mrBert's discussion Mavlink stuck
"Yes,Joshua. I have changed 3.3v ic regulator, right now it fine. Please see more detail at http://diydrones.com/forum/topics/apm-2-5-no-dataflash-compass-init...

You can start reading from the begining :)"
Mar 2, 2014
mrBert replied to def2att's discussion APM 2.5 No dataflash Compass init error
"Before I change 3.3v regulator IC I also checked voltage at I2C socket and found the voltage is less than 1v. After I have changed that IC,the problem is solved! Thanks to diydrones community..... :)before.pngfixed1.png"
Feb 20, 2014
mrBert replied to def2att's discussion APM 2.5 No dataflash Compass init error
"Thanks you a lot I also found this problem on my brand new APM2.5.2! I will tried to change this IC regulator."
Feb 12, 2014
mrBert replied to mrBert's discussion Mavlink stuck
" 


 








 "
Feb 10, 2014
mrBert posted a discussion
Mavlink stuck
Hi All,I have problem after updated Mission Planner to new version according to massage box that shown when I run the Mission Planner. I got stuck at  "Got param RC10_MAX", the error massages are show below.Please help me on this :)Thank you very…
See More
Feb 10, 2014

Discussions