ArduPilotMega USB conections

hi there, I just traying reset my apm board and I have CLI conecting bur in fly mode  is no conecting

I reload de firmware, reset de apm no results, any help?

pixhawk memory corrupted

Hello anyone, I am trying to start a drone Proyect with a pixhawk, I have an issue with arming the drone I have a memory corrupted message

some help wil be aprecited

bad compas health

After 3 auto flight, my apm start giving me this message"bad compas health" can on board compas be damage by vibration?

APM ARDUCOPTER TAKE OFF FUNCTION

Has any one just try  this take off function on the APM, ?

apm1 3 of them just stop working!!!

Ok, I almost done with this, after 10 great flies with my skyfun jet, I just try to install my apm 1 with IMU board on one of my Quad and it did it again this is the no.3 apm board that suddenly stop working, the firts one stop to have signal input f

apm 1 , quadcoter no sensor..

apm 1 , quadcoter no sensor..

no trotle on rt or auto mode with apm 1.1.21 any help?

no trotle on rt or auto mode with apm 1.1.21 any help?

support from this page?

is any where in this site a support area, ?

help!!!!! apm pilot

ok, I just did all the process 10 time, still unable to setup radio on ardupilot mega, same with serial monitor radio on , input and output working but software is no able to setup radio ????/

any idea

xbee range test

I have a simple question How to test the xbee range?

PID tune

ok, have a question on aeroquad configurator we have PID for stable mode Acro mode and PID for altitud hold and position hold, wicth are those on the ardupilot megaplanner for gps position an hold altitud mode?

blimpduino control board

Hi, there where  can get something similar to the blimpduino board it is discontinued and I have a proyect with it any information will be appreciates

imu usb conection

Hi, there I'm trying to reload apm code but is impossible, I just check everything this is message I get

tubine quad?

would be that able to build a turbine quad, with arducopter hardware and code, what happens the torque effect? yaw control?

xbee pin out

Hi there, I need to conect Xbee with IMU sensor board, but breakout board on back order, is there any way to connected it with out it?

ardupilot problem

Hi there, I traying to have my UAV proyect running, but after all electronics installed an tested, sudenly

my esc is warning and getting arm keep beepeming full trotle stick, Rc electronics is ok, I just reload

firmware, erase eeprom, same results esc