Members

Fever issues in the motor.

Hi everybody, I made a diy drone and specificatino is as below. FCC : pixracer r15ESC : Hobbywing Xrotor micro 60A 4in1Motor : T-Motor 1300KV When I tried to take off the drone, it can fly somehow.But after flight Motor is too hot. Is there any problem with combination of components?

Read more…
0 Replies

Is there a "popular" flight controller like how the Ender 3 is to 3D printing?

I'm looking to get back into ardupilot and I'm a little overwhelmed at the flight controller options. My last board was the original ArduPilot Mega from 10 years ago. I'm wondering if there is a reasonably priced, popular/standard flight controller out there that is reasonably futureproof. I would say something similar to what the Ender 3 is to the 3D printing world. My short-term goal is a single-rotor heli with GPS hold - I notice many FCs are primarily designed for quadcopters.So far I'm…

Read more…
1 Reply · Reply by Chris Anderson on Sunday

FS-x6b not communicating with F4 V3s Plus

F4 V3s Plus does not have IBUS port. Tried ti use, as advised a free UART. Inmy case RX 6 and set:serialrx_halfduplex=OFFserialrx_inverted =OFFI did set the receiver to IBUS as well as on my FS-i6 RC.That did not solve the problem.I tried another approach.Connecting the data wire to PPS as in the manufacture's instructions. Changed the setting in Betaflight and the FS-i6 to PPMtried bothserialrx_halfduplexserialrx_inverted OFF and ONStll the FC does not communicate with the receiver. Any ideas?…

Read more…
0 Replies