Comments

• Admin

  Thomas J Coyle III November 7, 2014 at 10:24am

  Hi All,

  I am planning on building an RMRC Anaconda and configure it with a Pixhawk. There is a great Anaconda discussion thread on RCGroups, but I would like to know if any of the ArduPlane User Group members has successfully configured the Anaconda with a Pixhawk and got it to fly successfully?

  Regards,

  TCIII AVD 
• rony September 13, 2014 at 2:22am

  Hi guys, I can not download HIL for ardupilot; however,  i can download ardupilot for helicopters; please see the forum post i made on the issue ;http://diydrones.com/forum/topics/pixhawk-set-up-problems

  can anyone please help me, i am stuck because i can not check my stick inputs at all for the simulation tab. I do not want to fly the plane without testing it; any ideas please

  rony 
• 

  Max LEe September 1, 2014 at 8:43am

  What is the proper level calibration method for a flying wing like the RVJET? I am having a tough time getting FBWA and LOITER to work correctly without the aircraft diving into the ground. I almost have to pitch the aircraft 25 degree nose up for it to fly level. that doesn't seem right?
• Anton August 12, 2014 at 11:21am

  To developers:

  Some bugs found, described here

  http://diydrones.com/forum/topics/some-bugs-found?commentId=705844%...
• 

  Eric July 8, 2014 at 7:53am

  Hello,
  I bought a skywalker with apm 2.6 & fpv, I learned the basics of piloting aircraft manual. I would take a few days of training to learn the basic use of mission planner and apm 2.6 against remuneration. I am ready to move me in europe and to provide the material, I have not found anyone in France for training so if you can provide me with this please do not hesitate to contact me
• Kobus June 26, 2014 at 6:48am

  I am using old firmware 2.74 to be precise 

  so what you think I should do is upgrade the firmware and then use this setting?
• Kobus June 26, 2014 at 5:33am

  @Dave Smith

  Hi Dave thanks for the reply

  I switch my radio on first then plug plane

  then I wait until plane has got solid blue for gps lock

  then I go to mission planner and click connect

  motor starts up for a couple of seconds and then stops

  I dont think there is a "arming" feature for planes?
• Kobus June 26, 2014 at 4:31am

  Hi 

  When I connect to my ground station my plane's motor starts to run for about 3 seconds and then stops again.

  I don't know how to fix this problem, it is very dangerous 

  If some one knows how to fis this please help

  Its and apm 2.6
• 

  Ravi June 1, 2014 at 7:44pm

  to control throw in auto mode or FBW mode. lower the values of rll2servo_imax and ptch2rvo_imax parameters. do not lower than 500.
• 

  turdsurfer June 1, 2014 at 2:17am

  What is the proper method to limit the control throws in Arduplane for an airframe with large control throws (e.g. a 3D plane as an extreme example)?

  Should I lower the P gains, or should I put my transmitter into low rates and calibrate it like that in MP?