Hi All,
I have been flying the SkyWalker with great success. However when I reboot the APM (2560) I lose the configuration. It keeps the waypoints but the configuration goes back to a default setup.
This happens if I press the reset button or remove
Read more…Hi All,
I have stabilize and FBW_A working well however when I change to RTL the plane returns close to home then gains altitude and drifts with the wind.
The attached picture shows the plane's path drifting with the wind.
Can someone help me tune t
Read more…Hi All,
I am having an issue with the voltage sensor – I just can
not seem to get it to read a voltage. It always displays 17.8 volts. I have installed
an AttoPilot Current Sensor Board. I am using the monitoring number 4 (current
and voltage). I can ge
Hi All,I am using the throttle fail safe and have it configured and working. The issue I am having is I dont know how to change the modes.If I test the failsafe in the CLI it works but its using FBW_A. I would like to use RTL as the failsafe mode.I a
Read more…
Hi All,
I have stuck a ArduPilot Mega to the side of my Trex450 to see how it performs with the vibrations.
I noticed a lot of drift from the IMU, for example if I change the pitch and only the pitch I notice the IMU thinks it is rolling as well. Th
Read more…Hi All,
Hi All,
I recently crashed my SkyFun delta wing from HobbyKing. Does any one know where I can purchase just the foam plane from? I dont need the servos, ESC and motor.
Regards
Simon
Read more…Hi All,
I was flying my plane today and found the following:
Stabilize was working nicely. Especially with no throttle, it would glide beautifully.
FBW_A: worked well.
FBW_B: worked well when I turned off the air speed sensor.
Auto: I had to reduce the
Read more…Hi All,
I am posting this from my flying site so I can test straight away.
I am getting very limited servo movement on in all modes other than manual. It’s not enough to control the plane.
What do I need to trim/adjust to get more servo travel?
Regar
Read more…Hi All,
I have my Skywalker setup with an ArduPilot (2.6.2), Shield (V2) and ArduIMU (Flat). I am experiencing 2 main issues and would appreciate some advice sorting these out:
I don’t have any throttle on any of the “Auto” modes including FBW_B. Thro
Read more…