"So it seems as soon as I posted that reply, I figured out how to fix the yaw issue and now I have a new issue: The safety prearm checks. Here's what it says
PreArm: Accelerometers calibrated requires rebootPreArm: GPS HDOP 5.2 (needs 2.5)PreArm:…"

"Update: I got past step 10, it turns out my RC wasn't calibrated. The firmware was uploaded properly, and the failsafe was also set up without issue. This isn't necessarily an issue, but more of a space saving question. Is the External GPS…"

"I just wanted to point out that the Lexus Hoverboard was a joke video. They buried a conductive metal track underneath the concrete so it followed a certain path. Great video, though! Bill Piedra said:
It's certainly been done before, but you might…"

"I think he means making a hoverboard as in an actual hoverboard. Where would he put the stickers without a hoverboard? Andre K. said:
....so , by "design" you mean to choose colour and put on stickers ? :)"

"Hi,
Sorry I didn't get back sooner. I used a Nimh battery on the receiver and it turns out it's fried because of the charger I used to be using on the battery I had. I got a new battery and charger, so that isn't a problem anymore. I ordered a new…"

"The way I look at it is, if you don't actually break any of the cells, you can separate them to the desired separation and connect them with the proper wires and they'll still carry the gathered power to your drone hardware.
I don't know as much as…"

"Receivers work by getting a signal through the air from the transmitter. There are different types of receiver signals: PPM (Pulse Position Modulation), PWM (Pulse Width Modulation), Satellite, and a few others. Most, if not all, FCs use PPM to…"

"I recently completely dismantled my quadcopter, and now I'm going to start over.
I'm going to start by doing away with the PDB I have on it (Probably should've mentioned that; It might've been the problem) and use the Flamewheels built-in power…"

"Hello all,
I bought a new battery and propellers yesterday. In addition to being completely dead, the old battery was very swollen. It was on the bottom layer of the frame, so I only got to see its condition when I pried it out. I'm probably going…"

"Matej,
I did a little bit of research and found an answer for you.
There are three measurements to propellers. The first is, of course, the diameter of the prop. The second is prop pitch. This is how high the four props could lift the drone per…"

"Update:
So with the battery on my quadcopter, I measured it before charging and it said 0.04V. I was a little surprised. I then measured each cell individually and the first cell read 0.01V, the second one was 0.0V and the last cell was 0.03V. Then,…"