"Hello,

I installed APM 2.012 and after a reset I received this message: "EEPROM format version 2 not compatible with this firmware (requires 2)". Is it normal?

Thanks,
luca"

"Hello Doug,

I installed APM 2.012 and after the reset I received this message: "EEPROM format version 2 not compatible with this firmware (requires 2)". Is it normal?

Thanks,
luca"

"Sorry, my last question was for Doug...

Frank, I don't think it's correct loitering if the last WP is "land". I tried (HIL) the last release and now it seems work correctly, it glides to the land point! I still have some problem to upload WP. I…"

"Frank,
 
   I had very good flights and landings with APM 1.x, now with 2.x, for example, in a 10 wp mission when the plane reach the wp #9 (wp #10 can be a land command or a normal wp) jumps directly to loiter on home.
I'll try to workaround the…"

"I've the same landing problem with 2.011. I've also difficulties to upload waypoint from the mission planner (USB), sometimes it works, sometimes it doesn't
 "

"Chris, you're right, we have to test everytime the plane on the ground before the takeoff. I do this always but this afternoon when I tested "stabilize" I was focused to check the movement of the surfaces and not on the direction... :-("

"Doug, Andrew, today I had the same problem with my Futaba 10CH. I was at 30mt height, I switched to Auto and the plane (at full power) dived vertically! Wow... what a surprise! In a second I recovered it but there was a lot of adrenaline in the air…"

"Doug,

I'm using both HK and Q (57,6 Kbit).
Main problems I found in HK (HIL and regular flight):
- no attitude data
- read and write WP often fails
- in "control", "set mode" doesn't work

Thanks"

"Doug, when, from the GCS, I download missions (5/6 wp) or I try to upload new waypoints I have often timeout errors, I have to retry 2/3 times. So I can't understand if it is a CTS problem or a sw issue.

Thanks for your answer."

"Hi Doug, Hi Chris

sometimes I've some fails on send and retrieve data from the UAV (waypoints), I'm using XBEEPro 2.4 GHz and these adapters:

http://www.sparkfun.com/products/8687
http://www.droids.it/data_sheets/990.001%20datasheet.pdf

Can be…"