Best Camera Gimble and Landing Skids

I'm currently searching for the right AP equipment.  I'm currently using a gopro 2 but will soon be getting a hero 3.  I using 6 of the available 7 ch on my receiver.  I would like to hear from the diydrone community on what u use or what new products are on your wishlist. I have a dji f550, stock motors, apm 2.5

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –

Replies

  • There are some very expensive gimbals out there which i feel are grossly over priced, but there are now some reasonably priced ones coming onto the market that will do as good a job for a much lower price. 

    The last two I bought were from iflight RC. These are very well made. The stabilizer they sell is a bit of trick to get it up and running, but once its working its very good.

    FoxtechFPV also sell a few good models http://www.foxtechfpv.com/

    http://www.iflight-rc.com/product/Brushless-Gimbal.html

  • I'm using an Arris 2000 under my F550. it's very well built specifically for the Hero 3 without the case and is excellent from the factory. All I had to do was mount it and add power.

     

    http://youtu.be/NPpxj_R1ZGA

  • Not sure what you're trying to spend, but i'm just entering this 'game' so I'm starting low - just ordered a Tarot T-2D after a lot of research - was originally going with the rctimer gimbal setup until i found the Tarot. I've spoken to users who own both and they say the tarot is an improvement, and has an overall smaller footprint. 

    https://www.youtube.com/watch?v=PMVDZ1mBmmc

    man these guys should be paying me lol

  • IF you want a good quality gimbal then you need to do three things.

    1: buy the TRUE alexmos gimbal controller from somewhere like csg shop

    2: buy or wind yourself some motors (iflight-rc.com)

    3: build yourself a gimbal.*

    *if you want some plans I actually designed a gimbal out of 5mm carbon fiber sheets for the bgm4006's form iflight. The design is just a bunch of sheets you glue to a 5mm think material of your choice and then cut out. You will need a bearing though....

  • This is the reason I'm looking at nex5/7
    Much better just heavier.
  • Honestly if your looking for AP equipment gopro is NOT one of them!

    unless you swap lenses and even then its not the best solution for quality

  • I am curious to know what do you think of the Tarot brushless gimbal and stabilization system.

  • Although I currently don't use a gimbal I will soon be buying a hero 3 black and am looking at the Aeroxcraft gimbal and the yun1.

    Although I feel I may just skip the gopro and go for an nex5/7.
This reply was deleted.