This has been reported in Github!
I am using a few CUAV M8N GPS receivers as the M8N chip is great!
With the Rover code there is no problem to arm but the plane totally refuses to arm. It says GPS1 configuration fail (or something very similar)
As this
Read more…This has been reported in Github!
I am using a few CUAV M8N GPS receivers as the M8N chip is great!
With the Rover code there is no problem to arm but the plane totally refuses to arm. It says GPS1 configuration fail (or something very similar)
As this
Read more…This has been reported in Github!
I am using a few CUAV M8N GPS receivers as the M8N chip is great!
With the Rover code there is no problem to arm but the plane totally refuses to arm. It says GPS1 configuration fail (or something very similar)
As this
Read more…Have, by any chance, skid steering stopped working?
I used it a lot last summer but when the spring finally has started to come, here in the north, it was time for testing.
Everything looks OK i MP and my sticks changes Throttle and Roll but nothing co
Read more…I wanted to post this request in Github but I cannot find where to place a Feature request.
As many planes are too small to mechanically create exponential aileron movements it would be very beneficial to to this with MW.
More up than down.
I understand
Read more…APM Copters are setting their home position when arming
APM Planes are setting their home position at power on
Why this???
I really appreciate APM copters behavior as it RTL to the place it was started
I would NEVER want a plane to RTL to a position wher
Read more…Dear Michael
Happy New Year!
Mission Planner is really awesome and I love it.
I have tried to mention this before but still MP shows some strange behavior sometimes.
Currently USB-connected to Pixhawk with ArduRover v2.51-beta software. All of a sudden t
Read more…It's a brand new Pixhawk. (My fourth)
- The very latest Mission Planner build 1.3.31.1
- The latest Plane software 2015-08-11
After successful firmware update Mission Planner cannot connect at any speed.
I have tried with another computer, another versio
Read more…Is the a way to see that sonars, connected to a Pixhawk, are working?
I have been through all parameters in "Status" without success.
Thanks
Anders
Read more…On my seaplane, not yet flying, I found a dangerous issue!
As the plane has Ailerons but no flaps I have connected the servos on RC5 and RC6 and set them as Flaperon1 and Flaperon2.
On the transmitter I have a 3 position switch for Flaps and output to
Read more…I have two motors driven by Turnigy Multistar 30 Amp BLHeli Multi-rotor Brushless ESC 2-6S V2.0.
Connected via a Y-cable to the Pixhawk port 3.
When everything is connected and the system is powered up the motors refuse to start when armed.
If I detach
I know I have read you said you will change from 32 bit to 64 bit input so it's possible to use the Pixhawk with a Piksi for high precision RTK system. When will this be implemented?
RTK doesn't seem to be working yet. When the Piksi enters "Fix RTK"
Read more…I have a second Pixhawk and uBlox for my rover project. It stands absolutely fixed close to a window but in the Fligt Data sceen of Mission planner it looks asthe rover is shaking, tilting and turning. Sometimes it looks as I'm rolling and looping. I
Read more…