"Sorry to bring this thing back up.

I fixed the problem. My receiver was being powered by an old multi power adapter brick that barely supplied 200ma at 12V. I switched it to a big juicy 12v power supply and the picture is perfect. Thank you all who…"

"is my 800mw TX legal?"

":O"

"Yes, It works, however I am getting some crappy signal on most of my channels. I'm not blaming it on this system yet because I haven't done much troubleshooting to look into it. The merchant is very friendly, however don't expect much in the area of…"

"Yes but they were too big for the 3.2mm shaft. Chris could you recommend a trusted adapter + prop for a 3.2mm shaft for my easy glider pro?

Thank you"

"Thank you :)"

"No i didn't, now I did, and it is working.

Now if only you could tell me how to fix FedEx's shipping delay"

"Thanks I'll just wait to upgrade to V2.

Don't worry I have Red and Black for Power, TX is Red with a yellow piece of tape on it."

"Thanks Chris, worked perfectly. :)"

"No actually I figured out the issue, The problem was that in my ArduPilot_2_6 configuration I had the GCS_Protocol set to something other than 0. My misunderstanding stemmed from the lack of comment in the header file. It says option 0 is for…"

"automatik, I just uploaded the code you provided and everything is working perfectly :)

I could have sworn i was using that code version already but thank you very much for helping out, ArduStation is receiving data as well :)"

"Thanks for the response,

automatik, yes as far as I know I have the latest firmware downloaded, I got it from the google repository recommended on the ArduPilot page. It is ArduPilot_2_6.

Chris, I have included the AP_2_6_header.h as well as the…"