About

Gender

Male


Location

Linz


Please tell us a bit about your UAV interest

im actually trying to develop a handheld 3-axis stabalized camera gimbal


Hometown:

Linz


Activity Feed

ChrisAT posted a discussion
Hello,I’m trying to build a helicopter which can be operated under extreme environmental conditions (high humidity and light rain). For this reason I’d like to protect the autopilot in a watertight box. Of course this is a problem for the internal…
Mar 1, 2017
ChrisAT replied to Duncan McDiarmid's discussion Reading IMU angles from SimpleBGC using serial and an arduino
"I never tried it but using the serial interface should work. I found an old document about the protocol specification: SimpleBGC 2.3 serial protocol specification - BaseCam Electronics
Maybe this works for you.
greetings, chris"
Feb 19, 2017
ChrisAT commented on Tersus GNSS's blog post Shutter Synchronization with PPS Signal
"Unfortunately you are just able to trigger the camera. The problem is, if your camera needs to focus there will be a delay between the trigger signal and the capture. I personally prefer using the feedback signal (flash signal) for logging. In my…"
Feb 13, 2017
ChrisAT replied to François Kneib's discussion Pixhawk bad power circuit after crash.
"Hi,powering the 3Dr Lea6H with a UBEC will work. But does the pressure sensor works? according to sheet 6 (in schematics) it's also powerd with VDD_5V_PERIPH?
chris"
Jun 9, 2015