About

Gender

Male


Location

Perth, Western Australia


About Me:

I live in Perth Australia.


Please tell us a bit about your UAV interest

I'd like to build an arduboat


Hometown:

Perth


Activity Feed

Darren Smith posted a discussion in ArduBoat User Group
Hi,I have SKID_STEER_IN set to "1" for my dual motor boat which responds to the throttle and roll (Channel 1 & 3) inputs from my transmitter.I would prefer that it responds to throttle and pitch (Channels 3 & 2). I'm using APM Rover 3.1.0. 
Jan 9, 2017
Darren Smith replied to Arnaud Vandecasteele's discussion How to setup "Current PWM" in flight mode to listen another channel (input)
"Solved. 
Looking under the config/tuning, I found MNT:MODE_CH and changed it to 5.  Now everyone in my family is happy. Darren Smith said:
Hi,
I'm using Rover v3.1.0 and want to change the flight mode switch to channel 5 from my transmitter. 
On…"
Jan 9, 2017
Darren Smith replied to Darren Smith's discussion Rover Mode Switch Input Channel
"Soved:
Backdated MP to v 1.3.41 and now have access  to the full parameters list under config/tuning"
Jan 9, 2017
Darren Smith replied to Thomasss's discussion Mission Planner 1.3.42 no Full Parameters List
"Solved;
-I backdated MP to v 1.3.41 and now have access to the full parameter list.  #thanksdonald Darren Smith said:
I tried opening MP v 1.3.43 without connecting then opening Config/Tuning but it only lists Planner on the left panel (no options…"
Jan 9, 2017
Darren Smith replied to Thomasss's discussion Mission Planner 1.3.42 no Full Parameters List
"I tried opening MP v 1.3.43 without connecting then opening Config/Tuning but it only lists Planner on the left panel (no options for Advance Parameters).

Craig said:
open MP and without connecting go to config/tuning and check the…"
Jan 9, 2017
Darren Smith posted a discussion
How do I configure the input switch to change modes for my ardurover (boat)Mission Planner 1.3.43Apm: Rover v3.1.0There's nothing listed in Config/Tuning>Standard Params
Jan 9, 2017
Darren Smith replied to Arnaud Vandecasteele's discussion How to setup "Current PWM" in flight mode to listen another channel (input)
"Hi,
I'm using Rover v3.1.0 and want to change the flight mode switch to channel 5 from my transmitter. 
On Mission Planner, I'm looking at; Config/Tuning>Standard Parameters, but there's no FLTMODE_CH parameter. 

How do I change this?  (feel free…"
Jan 9, 2017