"@Marcell,I understand this's problem. So, what is next? New version of clone... adapted firmware... noI think local buyer in China don't know about the problem with clone and AC3.4 firmware in the future. It's a problem. Chinese buyers like to Buy…"
I'll try 3.4 version a little later.
I think clone and original flight controller can use wifi function without any limitation. Because flight controller use standart serial port for communication.Small joke: You are using original…"
"@ DR WHO
My tests for wifi connection with ESP8266 module:
Ok - PixRacer(PX4) + QGC 2.9.7.bСan't connect - PixRacer(AC3.3.4) + QGC 2.9.7.bСan't connect - PixRacer(AC3.3.4) + MP1.3.38 UDP mode with port 14550Сan't connect - PixRacer(AC3.3.4) +…"
I know about PixRacer GPS port pinouts. I made a special cable for Pixracer GPS Port, so I can connect GPS and PX4FLOW module. I tried connect i2c external led. It's work fine. I think cable don't have any problem.
Can I use nsh mode to…"
"A simple sketch I wrote up for the Arduino Nano. I try to use I2C interface for SR04 sonar
[ HC-SR04 5V ] <=> [ Trig(8), Echo(9) ArduinoNano 5V SDA(A4), SCL(A5) ] <=> [Bi-Directional Logic Level Converter 5V 3.3V] <=> [Rixracer/Pixhawk…"
"My Futaba R6203SB receiver doesn't work with Pixracer, but Futaba R6208SB work fine.Both receivers R6208SB and R6203SB work fine with Pixhawk. Anyone using Pixracer with Futaba R6203SB?R6203SB_Pixhawk.jpgR6203SB_Pixracer.jpgR6208SB_Pixracer.jpg"