After doing so many calculation I am stuck at
how can I increase the flying time and without compromising the maximum height
Steps considered
1. Reducing weight
2. Low Kv or high Kv motors
3. smaller prop or bigger prop
4. prop pitch
5. Hgher capacity batte
Read more…What are the best motors which can give me maximum flight time. Or where can I find ultra low Kv high quality motors
Read more…Hi
By looking at Randy's videos I am planning to buy one low cost heli like TREX 450 (or any other which require minimum tuning from standard values) but I have few questions
1. Should I buy a flybarless unit or flybared unit.
2. Do I need a tail gyro
3.
Read more…Hi just looking at these features, I did not find explanation of these Do Action items. Few these actions seem to be used in Auto mode. But few actions like STORAGE_READ, CALIBRATE_GYRO dont.
1. Can someone provide a good explanation of these Actions
Read more…Shouldn't APM Planner Gui give direct interface to control these channels actions because setting these channels everytime we need either CLI or Arduino IDE
Read more…I am using Gaui 330X frame with 2560 and firmware version 2.0.49. I had tried a very wide rage Rate K and Rate I values to tune this machine. In stablize mode I had done levelling and releveling multiple times. But I could not make this mode work lik
Read more…HI
When I tried to change the RATE_ROLL/PITCH/YAW values using APM Planner 1.0.86 or its older version 1.0.68, they refused to change. I tried several times then they got changed once. Then I tried again and this time every time there was write error
Read more…I am a novice with Autopilot thing, but have quite some experience with building of Helis and planes. While programming the Autopilot code in mission planner we have level command.
How do you guys level properly.
If not leveled properly what disaster
Read more…Trying to correct the measurement what I am getting from 1260MB. When i measured I found out that the sonar was giving 36cm against a distance from ground of one meter. Guide me if this function is responsible for range calculation in AP_RangeFinder_
Read more…or what else do i have for altitude and position hold
Read more…