"Hi Richard,
Thanks for your message. Actually I don't follow this post any more since I stopped flying drones. By coincidence I found the message about your post :-)
To answer your question, the files are not downloadable indeed. Did you know the…"

"Well, I actually fly one of my R&D quads without c-clips all the time. The magnetic force is huge, especially when power is applied. Full power only moves the outer part about half a millimeter. Never have encountered a 'fly-away' of the prop, only…"

"Thanks for your replies Randy. I'm using the same version of MP. Meanwhile I did several reboots and till so far 3 distinctive values are reported for COMPASS_DEV_ID2.
So let's wait a while for other reports.
If you need me to do any additional…"

"The end is missing from my previous reply
So, when I change COMPASS_DEV_ID2 back to the value right after compass calibration, all is fine and no pre-arming warnings any more. I guess it's not very convenient to do this after every reboot, so I…"

"More investigations..Somewhere further on this thread I read Randy's comment about the software checking the compasses id's in order to detect a changed one. This made me redo the compass calibration dance, but FIRST zero the two compass-id's in the…"

"And the param files.32rc3-compass-initial.param32rc3-compass-after-calib.param32rc3-compass-after-calib-and-compassmot.param"

"Hi Devs,
Testing 3.2rc3 I can't manage to arm the quad because of "PreArm: Compass not calibrated" showing up in MP (v1.3.7).
I ran the manual calibration several times, but to no avail.
I have a PX4 FMU+IO flying really perfect on 3.1.2
Quad, X,…"

"Andy, did this work for you? I'm also having issues with altitude on PX4/PX4IO, even in 3.2-latest of june 11th. My report is on page 37 of this thread. In EKF-mode the altitude sticks at 15000 meters after a few minutes and in 'legacy'-(non-EKF)…"

"Tried 3.2-rc2 on my quad today (PX4 + PX4IO). There's a problem determining the altitude of the quad. When I enable EKF the reported altitude is 15000 and when I disable EKF the altitude remains at a steady 0. Even after waiting 10 minutes this…"

"Rob, as far as I can see in one of my recent RC7 logfiles (attached), I don't see glitches (do you?), all motors sound well.
I'm using a Futaba R-118F 40Mhz receiver. This one is not providing PPM out-of-the-box, however it's available inside the…"

"Finally a nice day in Holland: no wind so a perfect day to try out RC6 and out of curiosity, the autotune feature. I can only say it's perfect. Flight modes tested: stab, alt hold, loiter, rtl and auto. When I load the KMZ from an auto mission into…"

"Today I tried the ROI and noticed the same as you: after the first waypoint it behaves following the setting of param "WP_YAW_BEHAVIOR".
So what did I do...I manually inserted the same roi-command before each waypoint. You just save your mission to…"

"Hi all,
I just recently upgraded from my APM1 to PX4FMU+PX4IO. I experienced no issues installing firmware, as long as I use the Qupdate program. No success yet with MP.
After all firmware is installed (FMU and IO) the board connects to MP without…"