About

Gender

Male


Location

Beaverton, OR


Please tell us a bit about your UAV interest

For fun.


Hometown:

Oregon US


Activity Feed

Hien Nguyen replied to Randy's discussion Copter-3.3 beta testing
"Randy,
Thanks. I run into this issue earlier, and was stump, not sure what had happened. "
Oct 20, 2015
Hien Nguyen replied to Randy's discussion Copter-3.3 beta testing
"I thought you have to set MOT_SPIN_ARMED =  70 for it to spin."
Oct 14, 2015
Hien Nguyen replied to Randy's discussion Copter-3.3 beta testing
"Congratulations. Thanks all devs for your efforts.

I am already on 3.3rc12- Do I need to update to GA code? or is it still the same code and I don't need to update.

Thanks."
Oct 9, 2015
Hien Nguyen replied to Randy's discussion Copter-3.3 beta testing
"Here it isIMG_0816.JPG"
Sep 29, 2015
Hien Nguyen replied to Randy's discussion Copter-3.3 beta testing
"here's the log
https://onedrive.live.com/redir?resid=38BA3875BBC10887!3656&authkey=!AKqbVVnXuOsjmgg&ithint=file%2cbin"
Sep 29, 2015
Hien Nguyen replied to Randy's discussion Copter-3.3 beta testing
"I had the same issue and it went away after I covered the bottom of the GPS mast with copper tape."
Sep 29, 2015
Hien Nguyen replied to Randy's discussion Copter-3.3 beta testing
" I am on 3.3rc10 and I think I have the same issue with dataflash log - it seems mission planner either downloaded just a portion of a log or ready just portion of the log.

I am at work, I will try to upload the log when I get home."
Sep 29, 2015
Hien Nguyen replied to Randy's discussion Copter-3.3 beta testing
"Hi Scott,
Does the ground copper disk effect the MAG performance?
Thanks"
Sep 17, 2015
Hien Nguyen replied to Randy's discussion Copter-3.3 beta testing
"Hello folks,
I am running 3.3rc10 on pixhawk-lite - Just finished the autotune (2 steps, pitch then rool +yaw), a bit windy today (5 - 7 miles wind) so it took 12 minutes for pitch and 18 minutes for rool+yaw. After that it flew very good, stablize,…"
Sep 4, 2015
Hien Nguyen commented on Jethro Hazelhurst's blog post Balancing Carbon Fiber Props : The Right Way!
"If you are going to use tape - which side of the prop did you apply the tape? Top or bottom? Thanks."
May 26, 2015