Gender
Male
About
Location
Alberta
About Me:
Civil Engineer
Please tell us a bit about your UAV interest
I am Civil Engineer researching a cost effective way to provide aerial survey
Hometown:
Edmonton
Activity Feed
"Could you please provide the parameter again?
your link does not work.
Thanks,
Juan
Alex said:
Hi Nazrin,
I'm using a Canon SX230 with acceptable results :
The picture was done over a sunflower field, at 110m altitude.
If you want , try the…"
your link does not work.
Thanks,
Juan
Alex said:
Hi Nazrin,
I'm using a Canon SX230 with acceptable results :
The picture was done over a sunflower field, at 110m altitude.
If you want , try the…"
"Seppo,
I have a couple questions before ordering. Could please provide me an email? ( I just added you as a friend )
Thanks.
Juan"
I have a couple questions before ordering. Could please provide me an email? ( I just added you as a friend )
Thanks.
Juan"
"Thanks for your response Chris.
what configuration should I use in mission planner for good range in a rural area?
Thanks "
what configuration should I use in mission planner for good range in a rural area?
Thanks "
"Hi All,
I got a couple of these RDF900+ radios and they communicate okay to each-other from my copter to mission planner, However, the range is the same as the 3DR radios.
Do I need to change some configuration to accomplish longer range?
Can…"
I got a couple of these RDF900+ radios and they communicate okay to each-other from my copter to mission planner, However, the range is the same as the 3DR radios.
Do I need to change some configuration to accomplish longer range?
Can…"
"Bernardo,
Use value 14 in the RNGFND_PIN. that worked for me."
Use value 14 in the RNGFND_PIN. that worked for me."
"HI,
I purchased HC-SDR04 that has 3 pins connector and It finally worked for me last night. I have updated to firmware 3.2.1 (36b405fb).
Then go to the configuration/tuning tab and under Full Parameter list search for RNGFND_PIN and change the…"
I purchased HC-SDR04 that has 3 pins connector and It finally worked for me last night. I have updated to firmware 3.2.1 (36b405fb).
Then go to the configuration/tuning tab and under Full Parameter list search for RNGFND_PIN and change the…"
"Hi,
Great work!
I am new with the drones and I would appreciate if someone please guide to what autopilot I need for an autonomous take off and Landing for aerial surveying
I have found the Panda 2, APM 2.6 and PX4 FMU
Thank you in advance
"
Great work!
I am new with the drones and I would appreciate if someone please guide to what autopilot I need for an autonomous take off and Landing for aerial surveying
I have found the Panda 2, APM 2.6 and PX4 FMU
Thank you in advance
"
