Gender
Male
About
Location
Concord, CA
About Me:
Retired from phone companies, married many years, rving and rockhounding
Please tell us a bit about your UAV interest
quads, helicopters, planes
Hometown:
Clyde, Ca
Activity Feed
"I used the EPP and they were very resistant to crash damage.
Now I am using the APC and they break much easier.
I like the APC better because they seem to respond faster to motor rpms. Better hover and response.
I just carry more spares since they…"
Now I am using the APC and they break much easier.
I like the APC better because they seem to respond faster to motor rpms. Better hover and response.
I just carry more spares since they…"
"What do your ESC's and motors use?
Can they use the higher voltage without burning up?
Some ESC and some motors will allow higher voltages but some will not.
My motors and ESC's will only go up to 3 cells so I stop there."
Can they use the higher voltage without burning up?
Some ESC and some motors will allow higher voltages but some will not.
My motors and ESC's will only go up to 3 cells so I stop there."
"Did you make sure you do not have any trim on the throttle?
Did you set up the ESC's using the hand held controller from Turnigy?
Did you set up each ESC using the throttle channel on your transmitter?"
Did you set up the ESC's using the hand held controller from Turnigy?
Did you set up each ESC using the throttle channel on your transmitter?"
"Did you calibrate the ESC's to your throttle?
Did you use the hand held programmer for the Turnigy ESC'sto set them all the same?."
Did you use the hand held programmer for the Turnigy ESC'sto set them all the same?."
I am using configurator v1.2.1 and software 1.31 for my arducopter.The gyros do not show any movement when I twist and turn the quad.The acell pitch and roll move all over but the gyros stay centered and do not move.I ran APM_ADC test using the…
Can someone tell me what is the difference between these quads?Do they use the same boards?
"I also have the same problem. I am using Configurator 1.2.1 and flight software 1.31.
Save calibration results in a message update unsuccesful."
Save calibration results in a message update unsuccesful."
I am trying to use my DX6 and AR6000 receiver which use DSM and am asking if this transmitter and receiver will work with the Arducopter?If so, I will go back to trying to get it to acknowledge it.The green light on the oilpan stays on steady and…
I just joined the Ardu pilot Mega and the IMU shield/ oilpan.I loaded the drivers for Windows Vista.I plugged in the brain and started the Arduino.exeI need some help.I loaded the drivers OK3. - go to -> File -> Preferences and set the location for…
"Norbert I want to thank you for the build guide.
It certainly makes it easier to understand how to put together the seperate parts.
Good show!"
It certainly makes it easier to understand how to put together the seperate parts.
Good show!"
