Gender
Male
About
Location
San Diego, CA
About Me:
Manager of the DIY Drones warehouse in San Diego...
Please tell us a bit about your UAV interest
Learning, learning and more learning......
Hometown:
San Diego
Activity Feed
"Raph,
We are checking into this issue to find out where the problem is exactly.
If you have any images of those esc it would help to send them over, so we can compare to what we have here.
We will let you know what happened asap."
We are checking into this issue to find out where the problem is exactly.
If you have any images of those esc it would help to send them over, so we can compare to what we have here.
We will let you know what happened asap."
"@Eric, good post you actually beat us to it! I'm adding a tutorial that we drafted for anyone out there working on their arduimus, glad we could help out!"
"@Harry Lister, here's the pinout for the 6 pin ISP header on your programmer"
"@Yusuf Onajobi, the boards are available now!"
"Hi guys, there is a mistake with the initial batch of boards shipped out, please send us an email to help@3drobotics.com to get you set up with a fix! I apologize fort the mix up, we dropped the ball on this one. Hopefully it didn't cause many…"
"Hi Steve, send an email to sales@3drobotics.com so we can get you set up with a replacement cable, I apologize for the bad experience!"
"@Gary McCray, here's the part number for the led, APT1608SRCPRV. You can also get in touch with the store and can repair it for you. Let me know!"
"Gary we posted a schematic for the board, it is the same board as the old magneto,we only changed one resistor ( 200k for 0 ohms)... It is earlier in this post."
"sorry, I misunderstood your last post, this fix should be the only modification that needs to be done!"
"yep"
"Sid, check out "IC1" on the schematic... This still needs to be revised to show the new modification (no 200k resistor!)"
