"It would not let me comment on the post where you referred to me as being "strangely quiet". I have been kayaking and walking around that area for the past three days and have been too tired to reply. I realize the ambition of my auto mission (now…"

"Here is a screenshot of the mission. It left on 100% battery. Ignore the home, because that is where I did the set up from and uploaded the route. I had it set to 95M altititude RTL alt is set to 0 and it is set to return when it goes below…"

"here is a screenshot showing the route. it launched to 95M and was set to land in the same place it took off.Screen Shot 2015-08-05 at 8.36.43 PM.png"

"Thank you very much!!! Out of curiosity, how much does it weigh and how do you do the installation on the drone? will it stay on or not when installed?"

"does this work anywhere in the world?"

"Thanks, I searched for it along the path and no luck, so I am guessing that this is what happened. Going to have to look straight lines to figure out. Knowing that it left at full battery at an alt of 95M is there any way for me to calculate where…"

"Thanks for the clarification. I set the RTL altitude to 0 to avoid any problems"

"Just an iris+ with 10.5V battery and a gopro attached (not with the gimbal, but screwed on in the front. Don't have it climbing in alt to RTL."

"Between 40-60, a third of them were on auto pilot and the rest were manually done. Nothing seemed wrong with the auto when I used it before."

"No more contact with unit. Tried the "Last pos." command and then hit "lat./Long." To give me a rough idea of where it is. It gave me a reading that was along the mission."

"Tried that. Still did not get any signal. It went from beeping for when iris loses signal to beeping showing a 10.4V reading. Can't go out any more, because it is too late, but going to check in the morning."

"Note: I do not have an android, therefore no tower and have only APMplanner to locate the drone."