Peter Koppendorfer's Discussions (14)
Sort by
upload with Arduino
Hello
what I must change it in the 43 version to uploud it with
Arduino
I've tried it
Unfortunately, I've been getting a error message
Thanks
Peter
Read more…PID Tuning
hello,
I'm just about to perform the PID!
I would have to screw with my copter the P levels to be as down wit that I'm no vibrations!
But then I have too little influence from my RC
which parameter I must change so that the remote control had more i
Read more…compass not working !
Hello !
have just finished my new copter
but when I wanted to control the functions
I've always just north of the compass indicates noticed!
I've now changed the APM and the IMU board also the Compass
but always the same result!
also in the terminal a
Read more…no Signal
Hi,
i have no signal on the ESC cannel 3 and 4 !!
have somone a idea ?
Thanks
Peter
Read more…Mega going hot
Hi
Is it normal that this component is very hot? 97AG N03B on the Mega board
I had conect a short time-4S.
shall I change this component or a new board
where can I buy this component ?
Thanks
Peter
i killed the Mega !!!???
Hi,
I killed the mega ?
I accidentally connected to the mega-4S !!!
Since then breaks the tension along when I connect servos
can i change individual components or do I change the whole
board ???
Thanks
Peter
Read more…Arduopilot tuning for Rookis,
Arduopilot tuning for Rookis,I now have the arduopilot into my Maja system installed and first testsmadeNow I still have problems :1 . If the aircraft is in auto mode, if it turns, it makes the turn too long!2 . the aircraft is flying too slowly3 . T
Read more…No one has the same problem?
No one has the same problem?I still use the same software!I can not understand!ThanksPeter(Hello,now I've started the first flight tests.The RTL system works very well!But if I transfer the waypoints, the Telemtrie shows a speed of 220!I can only wit
Read more…Missionplan via X-BEE ?
HelloIt is possible, a Way plan with X-Bee transfer?GreetingPeter
Read more…X-BEE to X-BEE Problem !!! Help please
Hello,I have a problem with the connection ofX-BEE to X-BEEI use X-PRO XSC 9600 ModulesI am using on one side of a PC witha USB adapter boardOn the other hand, a Adafruit adapter board and Ardupilotconnected to GRD, 5V, RXWhich parameter I must chang
Read more…Big Disaster
Hello from Germanyit is normal that the ArduPilot Bord heat is on the bottom?Unfortunately, the ArduPilot Shield does nothing more.Beginning to have shone even the GPS lampBut now, no LED lights on the ArduPilot Shield.Have I made the Przessor off?Th
Read more…where i can get the Fun Jet Datas ?
Hello My Name is Peter from Germany !I am a Rooky in UAV Systems !!If Germans in these Forum please cotact me !!I want to fly a Funjet but i have no Codewhere i can get this Code ?Regars Petersorry for my bad English !!
Read more…