About

Gender

Male


Location

Orlando, FL


About Me:

University Student


Please tell us a bit about your UAV interest

I am making a fully autonomous UAV for a senior design project


Hometown:

orlando


Activity Feed

Ross Kerley commented on Mark Harrison's blog post Is a bicycle a UAV if a robot is riding it?
"That is awesome! 
 
Wouldn't it be an Unmanned Ground Vehicle?"
Oct 28, 2011
Ross Kerley replied to Ross Kerley's discussion PPM output waveform
"Neither the GUI or CLI report receiving any signals from the radio.  
What am I missing in the waveform?  
I haven't attached sensors yet, do they need to be present for it to analyze the PPM stream?"
Oct 19, 2011
Ross Kerley replied to Ross Kerley's discussion PPM output waveform
"the attached picture is the closest approximation to the PPM waveform that I have made.  It has 8 pulses of 1.5ms each, separated by approximately 0.250us.  The pulse sets are delimited by a single 3.75ms pulse.  
 
Should that timing be read by the…"
Oct 15, 2011
Ross Kerley posted a discussion
I am working on an engineering senior project to make a UAV.  My job is to get the plane flying, while two teammembers work on the payload.   The design criteria for the project required the use of a TI microcontroller somewhere in the project.  I…
Oct 13, 2011
Ross Kerley commented on Russell B. Sutton's blog post Polarity Protection for Turnigy 9x Tx
"I'm curious now, maybe you have Drain and Source swapped? If you disconnect the Gate altogether, does it still work correctly?"
Jun 3, 2011
Ross Kerley commented on Russell B. Sutton's blog post Polarity Protection for Turnigy 9x Tx
"My stock FlySky has built-in polarity protection.  It merely has a series diode on the positive battery input.  
 
I don't think your circuit will protect it from anything.  The body diode of your MOSFET will allow current to travel if the battery…"
Jun 3, 2011