About

Gender

Male


Location

oshawa


Please tell us a bit about your UAV interest

Just started. I seen my first one this summer at a nascar race


Hometown:

Oshawa


Activity Feed

Shawn Mason replied to Theo Moelich's discussion Optical flow sensor problems...
"Call Dany at canadadrones.com"
Jan 16, 2013
Shawn Mason replied to Theo Moelich's discussion Optical flow sensor problems...
"Same question"
Jan 15, 2013
Shawn Mason replied to Shawn Mason's discussion Number one motor will not spin. Any ideas? (FIXED!!!)
"After testing everthing I found that the 3D robotics power board was leaking battery voltage to the signal pin to motor 1. I cut the pin on the board and soldered the wire to pin. Everything is great now."
Dec 15, 2012
Shawn Mason replied to Shawn Mason's discussion Number one motor will not spin. Any ideas? (FIXED!!!)
"New info. This is my board from 3d Robotics. Checking with a ohm meter everything seems fine. But when I plug in a battery I have full 12V on top pin for motor one. All other pins read 0V. Is ths a bad board?1.jpg2.jpg3.jpg"
Dec 15, 2012
Shawn Mason posted a discussion
I have a Hexa copter. APM 2.5 board. I can not get #1 motor to spin. I have gone through and switched motors and ESC to narrow it down to no signal. I tried a second APM 2.5 board. samething. Please help
Dec 14, 2012
Shawn Mason replied to u4eake's discussion APM 2.5 with NEO-6M ublox gps (not 3DR LEA-6)
"Hi, I am a beginner. I built a quadcopter and bought the APM2.5 board with the 3DR-Ublox. Can any one direct me to where to start to learn how to use this"
Oct 17, 2012