Gender
Male
About
About Me:
love diy electroniks/mechanics
Please tell us a bit about your UAV interest
APM2 ON TREX600E and TREX450E
Activity Feed
"Yes a Schematic would have been great :)
Thanks"
Thanks"
Have finished a complete 3D model of APM2 in SketchUp8:)
-
Tedd Jensen Link to APM2 files
-
Tedd Jensen Mark Colwell Thank you very much.
"Randy
yea you are right its a risky job to Desoldering the GPS it was for saving some $$ and dead weight. I think I am going to live the GPS unit in place for now and try to mount the APM2 on the "gyro place" in stead of under the heli,hope its no…"
yea you are right its a risky job to Desoldering the GPS it was for saving some $$ and dead weight. I think I am going to live the GPS unit in place for now and try to mount the APM2 on the "gyro place" in stead of under the heli,hope its no…"
APM2 Manual/Pinout for TreX450-600 Setup with FUTABA TX/RX.... would have been a great help for all tradisonal helicopter users with FUTABA Radio.DSC06196 - Copy.JPGDSC06201.JPG
"Ok you can do the separation with cable but the worries is there any danger for any interferens?
Maybe it's better to de-solder the gps module and etch a new PCB for it ?
then you only need 3 or 5 cable.... it's what i can see in the EAGLE files…"
Maybe it's better to de-solder the gps module and etch a new PCB for it ?
then you only need 3 or 5 cable.... it's what i can see in the EAGLE files…"
"Does any body know....
Can Shield board on APM2 be separated by a 50 cm cabel?"
Can Shield board on APM2 be separated by a 50 cm cabel?"
