Gender
Male
About
Location
Morris Plains, NJ
About Me:
450 Heli
Please tell us a bit about your UAV interest
stabilization, RTL
Activity Feed
"Ok, I tried it today. It did not seem the loiter or RTL will hold the heli to one fix place, I could see after I made the switch, the heli will go up, then will move away from where it was but I have no idea if it had a location in mind... it moved…"
"In the meantime what is the status of using it on the traditional heli? Is it mutual enough that I can rely on it to RTL and autoland? I am trying to determine if I should use APM on a quad or heli.
Personally I prefer heli, because I like to look…"
Personally I prefer heli, because I like to look…"
In MP, I can see my radio input is working fine. However, it seems it doesn't control the quadcopter's aileron and elevator at all, when I increase throttle it just lift off and drift away. Rudder control is available though.Any idea?
"The heli holds very good with external gyro alone. However if I route receiver output to APM channel 4 input, route gyro to APM channel 4 output, the heli will wag seriously even if I dial the gyro gain to zero. So it seems the APM is trying to act…"
"I am trying to setup a 450 clone but the tail seems not working at all. If I use no gyro, the tail servo moves a limited range that won't hold the tail in flight at all. If I use gyro, the tail will wag even I set the gain on gyro to 0, so it seems…"
I notice when I move the rudder stick, if the gyro is plugged into channel 4 of the AC mega, it moves a lot slower, comparing with if I plug the gyro into receiver channel 4 directly. Any one notice that? I think it is for that reason the tail…
Hi all, first post, sorry for if the questions are duplicated and have got answered before some how... if you can point me to the links it will be very helpful!1) It seems I can not control the rudder servo at all... when I manually move the heli…
