Recently I notice there are some " pure " advertising post from Skywalker / TopXgun ect. Where some of the post being deleted some make it to the blog post. I'm not really sure if this type of " blog " have a place here or we shou
I have a strange situation where the whole system work fine when I first connect the power. But after a few minutes, the receiver suddenly stop working, do not react to transmitter input and the LCD also blinking red which means no binding with the t
Today I am flying a mapping mission. Plane take off and circle in home location in RTL mode while climb for altitude. ( I set the RTL altitude @ 350 M ) when it reach about 200 meter I put it to auto. The waypoint altitude is 170 M. It was descending
I am having problem with upload command from flight data. Eg Change altitude, restart mission ect. I do not have this type of problem with the previous Mission Planner. When I try to change altitude, a fail massage window appear. I also can not write
Currently we can only do radio configuration without connecting the Mission Planner with APM. There must be some reason MP prevent us from doing other configuration or at least can view other tab without connecting.
I'm setting up my new Skywalker with APM2.5 and power module. All work fine but I notice the voltage reading in the HUD is fluctuating within about 0.5 volt. It will not stay in one reading even though I didn't move anythings. The current also show 1
Is there any information about how to properly tune those PID in arduplane? P tuning is easy, but how about I and D. under what circumstances we need to increase or decrease the I or D value? A detail illustration will help a lot. Thanks