Gender
Male
About
Location
grampian,scotland
About Me:
im 60 yrs old and work as a heavy crane operator
Please tell us a bit about your UAV interest
i fly mainly sport aero type of flying
Hometown:
aberdeen
Activity Feed
"Hi does any one have the wiring diagram for the Xrock air modual please,many thank's"
"Can some one put me in the right dirrection to pull a request for CRSF protocol on the Pixhawk,many thank's,Marty."
Hi can some one please tell me if it is going to be implemented that we can use CRSF protocol with the pixhawk please,many thank's,Marty
"Many thanks to every one for the hard work and time they have put into getting this out to us,arty"
"Chris I would rather you take your time and get it right,Marty"
"Can any one tell me if the new JR X-buss will work with the Pixhawk please,thanks Marty"
"What is the better radio to get for the PIXHAWK,Spektrum or a Futata 8 with S Bus I have a JR 8XG at preseny,thanks,Marty"
"I just cant wait for it to be available to purchase,bring it on,Marty"
"I wish it was out now a great project to get together throug the cold dark nights,come on burn the mid night oil,Marty"
"Great news,I hope when its available it will be very compatable and as easy to use as the APM,great news well done every one thanks every one"
"Hi Leonard,on my radio a JR XG8 i have it set in accro mode but can have 3 flight position's,so i have my accro mode set to 100 rate 20% expo and the most important the throttle low end at 20% this helps a lot,Marty."
"Leonard,is it o/k now to do a Flip,Marty."
"my settings are the same as yours but ive got Accro P@6,the APM just gets better and better many thank's,Marty"
Hi when i do a download of the logs I get the following raw numbers, Accel X = 0.60 Accel Y = o.47 and Accel Z = -9.84 these numbers vary a little but remain similar through out the log,my real question is why is the Accel Z so…
Hi, once again my reptile is flying nice,ive one small problem,i love going high and nocking the power off and catching it,but when i do that the reat of the frame drops down,what parameter do i alter to cure this,your's,marty.
Hi All, When I do a test in the CLI of the sonar,all I get is a constant number 1068,this does not change when I lift or lower the quad is this cirrect or do I have a faulty sonar,many thank's,Marty.
