Did one test flight of my upgraded Iris/Iris+. Before flying I recalibrated the ESC's and recalibrated the compass. Took off in STD mode and flew for about 2 minutes making sure everything was working OK. I then switched to Loiter and the controls
Read more…I'm finally getting around to upgrading my Iris to Iris+ and I having a problem with Mission Planner. When I open MP and click the Config/Tuning tab I don't see the Full Parameter List to install the new Iris+ settings. I connected the Iris with bo
Read more…I'm having some trouble setting up the Tarot gimbal on my Iris (ordered both at the same time). I set everything up according to these instructions:
http://3drobotics.com/wp-content/uploads/2014/04/Tarot-gimbal-kit-IRIS-X1.pdf
Orange and brown wires a
Read more…Ok, I read through the wiki a dozen times. I can't my ground and air radios to connect. Is it necessary to connect the air radio to my laptop with a serial to TTL cable and save the settings to that radio before it can connect to the ground radio?
S
Read more…Hi- I'm a new (noob) Ardupilot user (just installed the V2 purple kit in a Sky Surfer) and I'm having an issue with the stabilize mode. I set the plane up on a bench stand (everything level), let the board boot up (I let it sit for a few minutes) an
Read more…