Gender
Male
About
Location
Waterford, CT
About Me:
I have been flying R/C for 22 years. I do 3D flying with giant scale planes and a little scale flying.
Please tell us a bit about your UAV interest
Just getting started, but want to skip a few steps.
Hometown:
Waterford, CT
Activity Feed
"here are the other 2 screen captures
Bernieflight plan with takeoff.pngflight plan with loiter.png"
Bernieflight plan with takeoff.pngflight plan with loiter.png"
"I hope that I am on topic with this. I have version 3.2 loaded into a Tarot Pro hex extended for 15" props. I am doing missions and have run into 3 problems. When I create a mission with Takeoff as the first command and follow it with several…"
"Randy,
My Pixhawk is powered by number 1 esc which happens to be a Castle Talon 35. The power gets to the pixhawk by the output channel 1. I read that I can power the pixhawk through the power port. Would that be the preferred method?
Bernie"
My Pixhawk is powered by number 1 esc which happens to be a Castle Talon 35. The power gets to the pixhawk by the output channel 1. I read that I can power the pixhawk through the power port. Would that be the preferred method?
Bernie"
"Randy,
I do agree that the data stopped suddenly. The hex spun about the left/right axis and when it hit the ground, the battery disconnected. When you suggest a brownout, are you referring to the receiver or the Pixhawk? I believe that I clearly…"
I do agree that the data stopped suddenly. The hex spun about the left/right axis and when it hit the ground, the battery disconnected. When you suggest a brownout, are you referring to the receiver or the Pixhawk? I believe that I clearly…"
"Hello All,
I have a Tarot Pro FY680 with a Pixhawk. Today while attempting to do an autotune, it finished the roll portion then during the pitch portion it all went bad. After pitching normally several times, the hex suddenly acted as if it was…"
I have a Tarot Pro FY680 with a Pixhawk. Today while attempting to do an autotune, it finished the roll portion then during the pitch portion it all went bad. After pitching normally several times, the hex suddenly acted as if it was…"
"I have a hex with Castle 35's. Could you describe in a little more detail how you went about adjusting the receiver endpoints and any other changes you made to the Castle's please? When I tried to do an all at once esc calibration, there was no…"
"Solved!
Throttle_max was set to a very low number preventing the motors from spooling up. I set it to 1000 and was good to go. Unfortunately the hex did flip over twice on my first attempt to fly. I will look over parametrs and the log to finf…"
Throttle_max was set to a very low number preventing the motors from spooling up. I set it to 1000 and was good to go. Unfortunately the hex did flip over twice on my first attempt to fly. I will look over parametrs and the log to finf…"
I have a Tarot Pro 680 hex with a new pixhawk controller. I have gotten to the point that the radio is calibrated, modes are set, gps and telemetry is fine. I have tied the copter down so that I can test its response to the controls but not have a…
