I want to simply tilt my camera platform with one of the "pots" on the 9xr. and I bought a gimbal motor (Ipower 2208) to do this and I want to avoid having to mess with a gimbal set up. I could have just mounted it on a servo but I really like the
Read more…I have my battery failsafe set to trigger at 9.8v. BUT it actually triggers at a much higher voltage, today it triggered at 10.64v
Here is a graph showing it.
Read more…I am using MP 1.2.95.
I have used the logs to view IMU data to see vibration in the Accell X,Y,Z befoe but now I do not see it anymore.
I will post a pic of my log. I circled the new column in yellow and the PM in Red.
I have the PM selected and I see
Read more…I just updated my mission planner from 1.2.84 to 1.2.95
and now I get an error message of GPS bad Health. I have the CN-06 GPS...
But I have 1.6 HDOP and 10-12 sats. I get a solid green light on the GPS and a solid blue light on the APM 2.5.
I have
I tried to graph my accel values but nothing is displayed. When I click on the ACCX and ACCY and ACCZ, and "graph this left" it shows the values in the top of the graph, but they just read "Value" and not "ACCX" and nothing is in the graph.
Can someon
I performed the LEVEL command in the MP CLI and I got the IMU "G: and "A" values as shown. Can someon please interpret these for me.
It is preceded by a statement involving the GYRO and ACCEL so I am faily sure it has to do with this, but I would a
Read more…I am getting an error in MP in the initial set up - see attached screen shots.
One is related to THR_MID and the other is THR_ACCEL_P.
I looked in the Full parameter and in Advanced parameters and I don't see them.
Where are they and what could cause t
Read more…I believe I am very close but I really need some help trying to figure out why the OSD will not show up and why MP will not connect when using 3DR.
I have the 3dr telemetry and MOSD-extra Version 2.4_r680 with CT 2.3.08 and I cannot get any data to sh
Read more…I have been building a quadcopter for about 2 mos.
I get the MP firmware downloaded just fine and I even get the 3DR settings downloaded and saved just fine, but when I try to connect to MP I get an error. (See screen shots).
I have solid green ligh
Read more…I have been building a quadcopter for about 2 mos.
I apologize if this is posted in the wrong spot; if so please advise.
I am using a CriusV2, 3dR and Minimum OSD.
I get the MP firmware downloaded just fine and I even get the settings downloaded and
Read more…