About

Gender

Male


About Me:

Novice


Please tell us a bit about your UAV interest

I'm looking to start out in RC's after taking an interest in the ArduCopter


Hometown:

London


Activity Feed

Antonio commented on Gordon's blog post Mode Switch Setup for Turnigy 9x
"Thanks for the guide Gordon!"
Jul 31, 2011
Antonio posted a discussion
Hello, I'm still trying to get my quad in the air. It previously had a fault with the XY gyro. The Oilpan was sent back to Diydrones for a fix. They replaced the XY Gyro, but this also affected the pressure sensor, so this was changed also. On its…
Mar 17, 2011
Antonio posted a discussion
Hello, I've had my arducopter for around two months and I still haven't managed to get it off the ground. (when I did, but I've now lost 3 props.) My problem seems to be that when pitching the copter the motors seem slow to respond to the commands…
Dec 20, 2010
Antonio replied to Antonio's discussion Not all motors arm correctly
"@Knuckles904 Thanks for the info but the battery should be fine for the power required. Unfortunately I don't have another battery to test.

@Chris

Well I've gone ahead and removed all soldered connections and replaced them with choc blocks for…"
Dec 1, 2010
Antonio posted a discussion
Hello.I have finally finished putting together my arducopter. Specs are:ArduPilotMega IMU Shield/OilPan Foxtrap 2.2ArduPilot MegaUBlox GS407 GPS XBee Pro 50mW Module with RPSMA (Series 2.5)2830-12 850KV 30 Amp motorsHobbywing Pentium 30A ESCsAPC…
Nov 29, 2010
Antonio posted a discussion
Hello.I have a Ublox unit from DIYdrones which is connected to my APM, which in turn is connected via USB to my PC.I've uploaded the following code and GPS information can be seen through the serial monitor./*  Example of GPS UBLOX library.  Code by…
Oct 30, 2010
Antonio replied to Ahmad Masalha's discussion how to configuration u-blox GS407 Helical GPS to ardupilot settings
Oct 29, 2010
Antonio replied to David spencer's discussion xbee - definitive set-up
"I think it's illegal for us to use the 900Mhz frequency in the UK so that leaves us with 2.4Ghz Xbees. I'm getting my bits set up this weekend and will be doing the above. Hopefully not too taxing...I'll let you know how it goes."
Oct 28, 2010
Antonio commented on Jani Hirvinen's blog post ArduCopter Development & Production news--Pre-orders now starting!
"Hi Jani.

Nice to see things in full swing!
Do you know when the new main frame board dxf files will be uploaded? Thanks"
Oct 27, 2010
Antonio posted a discussion
Hello. This is my first venture in RC so have doing quite a bit of reading on the boards. I'd like to purchase most of my 'copter components from the UK to avoid import tax and duty and was wondering what people thought of the below setup: Items…
Oct 25, 2010