Hi,
I would like to move my pixhawk between 2 different models, how do you backup all settings and configuration for one drone to allow the moving of the board to a different model, and later when its moved back how to restore all settings and config
Read more…Hi,
I have been running v1.2.75 for a while now and today it asked me to update to 1.2.76 however after the update all the flight modes in the mandatory setup screen are empty, the drop downs are blank and i cant choose a flight mode.
This has happened
Read more…Hi,
I have a ardupilot 2.5 powered quad, with 3DR Power module, 3DR 433 telemetry and lea6 gps, BL-2217/19 motors, turnigy plush 25 sc's and 2200 3S lipo turning 10 x 4.3 props. All calibrated and first flight was lovely, test stabilize, position hol
Read more…Hi,
Hope someone can help with this problem thats driving me mad. I have been keenly following and building UAV's since v1 of the mega. Heres my current setup.
In January i bought from 3drobotics:
1 x APM 2.5+ Assembled (side entry) with 433Mhz (europe
Read more…Hi,
referring to the ArduCoper Wiki under the section Optional Magnetometer i an trying to compile the suggested test sketch called APM_Compass_Test.pde.
I get the following error :-
APM_Compass_test.cpp:13:37: error: AP_Math.h: No such file or director
Hi,
Was out at test site yesterday preparing for maiden flight. I powered the system with the plane level and waiting until the flishing lights on the IMU went out.
The airframe was a boomerang 40 high wing trainer with an SC40 IC engine upfront and F
Hi,
Cant seem to get my head around this one.
I have an ArduPilot board and this is connected to the ArduIMU+ V2 (flat). Tx from the IMU is connected to Rx on the Ardupilot and everything is working as it should.
However i would like to investigate usi
Hi Everyone,
Can anyone help me to achieve the following.
I have ArduPilot, IMU+ V2 (flat) and some XBee 900Mhz Wireless modules.
I would like to use the IMU+ to measure vibration and send the information to a computer on the ground over wireless.
Has an
Hi,
One week ago i purchased a ArduPilot from CoolComponents in the UK. Along with FTDI cable and Shield (with airspeed sensor). I am powering the AP from a Futaba R607FS 2.4Gz receiver and controlling it via a Futaba FF9 with Futaba TM-7 2.4Gz mod
Hi,
Forgive me if this has been asked before but i have spent a couple of weeks researching and reading the forums.
I am looking at the KT-ArduIMU-20"">ArduIMU+ V2 (Flat) and notice that there are 2 servo out pins, not sure whether there are any rx sig
