About

Please tell us a bit about your UAV interest

Need to be in the air.


Activity Feed

Bill Evans posted a discussion
I finally received the 2.6 autopilot and will be installing it in a fixed wing.  I've looked high and low but can't find instructions on hooking up the power module.  It has two power connectors, why?  I assume one connects to the battery but which…
Aug 24, 2013
Bill Evans replied to Bill Evans's discussion start motor after launch
"Anyone?  I've looked through the forum for an answer but I'm coming up with nothing.  Surely, there must be a way to do this."
Aug 19, 2013
Bill Evans posted a discussion
Been a while since I've been here.  Life happens.I've ordered the new autopilot and wonder if there's a way, with the new APM, that I can tell it to start the motor after launch. 
Aug 15, 2013
Bill Evans replied to Bill Evans's discussion Motors start up AFTER I shut off transmitter
"I looked at the fail safe limit and it's lower than the min throttle setting of 1107.  Any more ideas?  I've looked over everything and can't find the source of the issue."
Dec 18, 2012
Bill Evans posted a discussion
Has anyone else had this happen?I have a 90A SBEC, 3s 8500 lipo, and of course the motor.  I programmed the ESC according to the instructions but nothing happens when I try to run up the motor.  That is, until I shut off the transmitter!  Then, I…
Dec 13, 2012
Bill Evans posted discussions
Jun 20, 2012
Bill Evans replied to Justin's discussion The eternal search for a daylight readable screen
"I use a Panasonic Toughbook model cf-19.  It's a bit expensive but it has a touch screen that you can see in sunlight."
Jun 11, 2012
Bill Evans replied to UAVOZ's discussion laptop for outdoor GCS
"I use a Panasonic Toughbook model cf-19.  It's a bit expensive but it has a touch screen that you can see in sunlight."
Jun 11, 2012
Bill Evans replied to Chris's discussion Drone sellers/Manufacturers/Affiliates
"Check out, www.airsdrones.com  They have some kind of program like that and they look pretty big."
May 7, 2012
Bill Evans posted a discussion
Can anyone tell me when the APM2 will be available?
May 5, 2012