Quanum Nova & cx-20 category?
It seem this new/cheap/popular quadcopter is worthy of a Category here. Lots of total newcomers & idiots like me looking for info. Bo
Read more…Bo Barry's Discussions (8)
Sort by
Expo settings - advice needed
I have a er9x and want to cut down my sudden & full movements of the ele, ail, rud controls. (I love the big throttle when I see my quad falling fast. It works great)
I tried adjusting the LIMITS, but didn't have much luck with it. I couldn't arm/disa
Read more…NTM 28-26A short shaft motors -some questions
I have some questions & hope someone can help
1. When the motor has a noticeable 'space' when you lift the top, do you have to 'toss' the motor? It looks like it is not repairable. I removed the C clip (which got lost in the carpet) and couldn't figur
Read more…Tips needed for this beginner
I can't develop a 'feather touch' on the controls for my quad. A 'full left' is disasterous, I've found.
Will setting the limits from -100 to +100 to say -30 to +30 keep me from making big mistakes?
I'm leaving the throttle alone, I need LOTS of it to
Read more…er9x APM2.5 WIRING HELP needed!
I am about to fly (successfully) today! I'm new at this, and have experimented with the flight mode setups until I'm almost crazy.
What has led me astray is how to hook up the receiver to APM wires! I do not understand the crossover, omitted channel
Read more…apm 2.5 mavlink connect problem
I had this earlier and somehow fixed it. I read info somewhere but cannot find it again.It hangs on a RC_7?? item.Help appreciated. Bo
Read more…Throttle cutoff switch on 9x - how to set it?
I've had a couple instances when cutting the throttle did not stop the props. So I got some long thick gloves so I could unplug the batteries. (10" blades)
I've tried setting the throttle hold/cutoff switch, but it won't work. Sometimes it speeds thin
Read more…Throtte & arm/disarm problems
2 remaining problems then I'll be ready to fly my APM2.5 quad! Help!
I cannot arm/disarm with my t9x transmitter, but can do so via Mission Planner. I had it working for a while, but I cannot adjust trim, etc to fix it.
Also the throttle jumps from 0%
