I arducopter code " define " Tab I see
/* Expansion PIN's that people can use for various things. */
// AN0 - 7 are located at edge of IMU PCB "above" pressure sensor and
// Expansion port
// AN0 - 5 are also located next to voltage dividers and sliding
I just bought the 3DR 433Mhz radio telemetry kit from DIYDrones..
The two boards of the 433Mhz looks same. After I received the kit I soldered the header pins to the boards and connected to the FTDI cable.
Now one board connects fine to the configura
Read more…I burnt the atmega 2560 on APM 2.. I replaced it with a new Atmega 2560..
I am unable to flash the board now with any of the firmwares with APM Planner..
Is it that the arduino bootloader is needed on the board to upload firmware..??
If so please tell m
Read more…I am going to order this motor from the DIY Drones' store
https://store.diydrones.com/Motor_AC2830_358_880Kv_p/ac-0004-05.htm
Now I saw the datasheet of this motor here http://stuff.storediydrones.com/A2836.pdf
where the motor is rated as it needs 40amp
Read more…I have few APM and OILPAN
But one of my first setup is APM with Atmega1280 and the older OILPAN.
In this board I cannot find any logs of my flying.. Why is that...??
Please help me out.. :(
Read more…I have a MT3329 GPS with the DIY Drones new firmware....( AXN1.30_2243_3329_384.1151100.1 )
I was to flash it with the old default NMEA firmware....
Where can I download the default firmware from....??
The main reason why I want to load the default firm
