Gender
Male
About
Location
Spring, TX
Activity Feed
Just wanted to drop a line to let everyone know that I have Xbee Telemetry Kits back in stock. They will be sold in two flavors:As a kit:Purchase Here Fully assembled:Purchase Here RegardsCharlieViper Flight Systems
"What CNC did you use?"
"I placed mine in this thing, but it requires a 3D printer. :)"
"Has anyone had any issues with the sonar data not being used in the altitude solution? I have ensured that it is enabled, and tested that I was getting output in CLI mode. It acted as though it was only operating on Baro. Log is attached. Any help…"
"What type of CNC machine is that?"
"I have them available in my store ViperFlightSystems . I am an authorized distributor or DIY Drones. Let me know if I can help.
Charlie"
Charlie"
"I also carry the same Arducopter Hexa kit that jDrones carries. Right now there are no individual parts, only kits. I currently have one in stock, but I am located in Texas, USA. I imagine that shipping might be cheaper from jDrones once they have…"
Will the ArduIMU (v2) work with Ardupilot? I would prefer the IMU route over thermopiles. Will the Ardupilot Mega have this built in?
"Original predator has downward tail:
Predator B has upward tail:
Reaper looks like Predator B, but bigger:
Comparison:"
Predator B has upward tail:
Reaper looks like Predator B, but bigger:
Comparison:"
"The ratio of killed is doubtful...as most of the time "innocents" are not. If that ratio were true, a manned aircraft could do better as a pilot would not be cleared to drop if there were doubt. Sometimes, the Military UAVs give the ground commander…"
"As a former F-16 Pilot, I was ill just reading about using the top gun soundtrack. I have been in fully immersive simulators and they were actually pretty good. If they could add a few more cameras, in addition to the sensor, they could give a much…"
"Would you please forward these to me?"
