Gender
Male
About
Location
Canberra
Please tell us a bit about your UAV interest
I like qaud copters and spying on neighbours
Hometown:
Canberra
Activity Feed
"I've been wanting to do a project like this for ages, but I'm years away from being at a level to be able to actually do it. MAKE IT HAPPEN YO!! :DPlease add a micro USB port on them also so we can run debugging over a laptop for prop test setups…"
"I came across this program yesterday which takes video input and outputs it to the DK2https://www.youtube.com/watch?v=vUeBBUfSGywhttps://developer.oculusvr.com/forums/viewtopic.php?f=28&t=11001Highly recommend it, as it does a lot of cool maths in…"
"Its documented in the motor setup page http://copter.ardupilot.com/wiki/motor-setup/
But looking at it again, its definitely not obvious other than a single picture with some tiny arrows. What probably would be better is a "motors reversed" sort…"
But looking at it again, its definitely not obvious other than a single picture with some tiny arrows. What probably would be better is a "motors reversed" sort…"
"I have checked it time and time again. But you are correct, it is a motor rotation problem, BECAUSE I had the frame set to "H Frame", which requires the rotation of props to spin the opposite to a common X and V frame (the usual quads I build)So…"
"Yep pretty sure its set correctly. I've watched it through Mission planner, and North was North, South was South"
So I've been looking on this site and others for a few hours now and I can't seem to find anyone with the following symptom...When I push my stick to the right, the copter yaws (turns) to the left. And visa-versa, push stick to the left the copter…
"So can I link both parts of the camera to each other via wire connectors so I can have them apart at different distances?I mainly want to play with perspective, lenses and how placing the cameras at different distances apart from each other affect…"
"How do you go about plugging the switch connector into the wrong port (which port did you plug it into?) On the pixhawk its labelled "switch" ?"
"APM 2.5. How does my symptom link to fly away behaviour?"
"I would expect, if its back heavy, wouldn't it just spool up the rear motors more to keep it level?The hard part also will be working out where the optimal center of gravity should actually be on a TBS like frame"
So I'm getting this weird symptom after a little while of flying in stabilise mode (haven't checked the other modes yet). If I have my elevator forward, so thus the quadcopter is flying forward, OR I'm holding it position fighting wind, after a…
"You guys gotta remember, there is a premium to companies making quads. They take the time to experiment and try different parts to find the right mix. They then tune and test the quads.
I liken it to a chef making a meal. While yes you could get…"
I liken it to a chef making a meal. While yes you could get…"
"Doh I missed it >_<"
"Don't forget to add Police Paddocks. Seriously, theres a lot of quad pilots flying there already.
http://www.rcgroups.com/place/285-police-paddocks-endeavour-hills-vic"
http://www.rcgroups.com/place/285-police-paddocks-endeavour-hills-vic"
"Yep I'm keen to do this. I'll spread the work to my other local flyers also."
"I hooked a 3S lipo up to it, heres my results, from simply holding it and testing.* Full engine, plus full collective = 37~38amps* Halfish engine, plus full collective = 31amps* Halfish engine, with collective enough to make it feel really light…"
