About

Gender

Male


Location

Mount Juliet, TN


About Me:

I am a retired engineer for IBM. I build and fly rc airplanes. I also do wood working.


Please tell us a bit about your UAV interest

I have purchased an adupilot mega which I completed and am having a problem with


Hometown:

Nashville, Tennessee


Activity Feed

Clyde Fussell posted a discussion
Is there a way to output the hud display to a Fatshark FPV display? If so how would one go about doing this. It would be great to use the HUD display rather than a separate OSD.
Nov 21, 2011
Clyde Fussell posted a discussion
Does anyone have the parameters for the zephyr that they would be willing to share? I have not got the plane yet, but it is suppose to ship this week.
Nov 20, 2011
Clyde Fussell replied to hamadivo's discussion Dummy Dome for camera
"Check ebay for dummy cameras and domes."
Jul 30, 2011
Clyde Fussell posted a discussion
I'm trying to add the camera tracking code to APM 2.2, and getting an error in test.pde.  The error istest:398: error: 'mix_mode' was not declared in this scopeIt seems that the mix_mode variable is declared in Parameters.h, but that is never…
Jul 25, 2011
Clyde Fussell commented on Ritchie's blog post Camera tracking, stabilisation, triggering and waypoint activity updated to APM2.1
"Will your code work with APM 2.2?
 "
Jul 19, 2011
Clyde Fussell commented on Ritchie's blog post Camera Tracking
"You posted some software in the APM manual for camera tracking, and I assume that it is the latest thing. After following your instructions and not being profecient in programming I could not get it to compile. I believe that there are some other…"
Jul 19, 2011
Clyde Fussell posted a discussion
I made my first flight this morning with a Telemaster being the aircraft of choice. Took off in manual mode to make sure things were hooked up correctly and trim things out, then switched to stabilize. The plane quickly stabilized it self and proved…
Jul 11, 2011
Clyde Fussell left a comment on ArduPlane User Group
"Can someone tell me the procedure to enable channels 5-8 out of the APM? I am not up on codeing as I should be, but am willing to figure it out. My transmitter is sending channels 5-8 to the APM, but no output to the servos from the AOM. I would…"
Jul 9, 2011
Clyde Fussell posted a discussion
I have an Autopilotmega, and an IMU with GPS. Air sensor, Xbee telemitry, and video. I am just setting things up and getting everything working. I put everything together, and load the latest code. When I run the GCS I notice that that I get…
Jan 26, 2011