I just installed Ver. 3.0.1, but when I power my Hexacopter (APM), I am only getting a single beep instead of two beeps before it goes into it's tune. The Mission Planner is not indicating an error, and I am able to arm the copter. Note: All motor
Read more…Should I update my APM with the newer PPM encoder before installing ver. 3.0.1 firmware? Note: I purchased Ardupilot Mega 2.5+ before March 1.
Thanks.
Read more…This may be a dumb question, but I moved my APM above my PDB and my flight tests went well. I purchased an acrylic dome to protect the APM, satellite, receiver and etc. My question is, can I mount my Spektrum AR8000 on its side? This will allow ad
Read more…I have my Compass Autodec = 0 and Compass Learn = 0. From what I have read throughout the discussions, it is recommended to have them off at all times. Is this correct? Do I need to check my declination values each time I change locations, to be s
Read more…Can someone direct me to a discussion, or give me some information regarding good mag field range using the Ardupilot Mega 2.5+? I have read a lot on the forum telling individuals their values are too high, but what is normal? What is expected norm
Read more…Since I started using a 4s 5000mAh 50c Lipo, each log does not read my battery discharge. Also, during flight the Flight Data interface shows when I Arm and Disarm the copter. Although, when I go to the log, the copter seems to show it is disarmed.
Read more…The copter will arm and disarm before takeoff, but once I am in the air I will get a sudden drop. When I land, I am not able to disarm. Also, I loose control of the throttle too.
I am not sure if it has to do with my Advanced Parameters settings or
Read more…I am trying to shoot video, but the yaw is very sensitive on my Spektrum dx7s. Do I need to adjust the radio, or MP?
I am sure there is something regarding how to adjust the YAW sensitivity, but I am not having in luck finding a solution. Any help
Read more…Is there a way to make various beeping sounds when arming and disarming the Ardupilot Mega 2.5+? Note: The only sounds I get is when I power the copter.
Thanks.
Read more…After 30 to 45 seconds I begin to loose control of the copter. I am not sure if some of the updates changed some of my settings, or I screwed something up.
I placed a brushless gimbal to the copter and I don't know if something from that is messing
Read more…I sent another post of the same message, but I messed up sending it to one individual. Sorry for the mistake.
My question is during the last two times I waited until the failsafe alarm went off to land my hexacopter. Although, when the alarm went of
Read more…I have been looking all over the place to make sure I have the fail safe setting/s correct for my hexacopter. I am using the Spektrum DX7s and AR800 with Satellite for my radio and receiver and Ardupilot Mega 2.5+.
My concern is I currently have a fa
Read more…