We are trying to tune a flyingwings Falcon 5 mapper pro flying wing. This may be a very silly question but is there an obvious way to slow down ground speed in auto?
We have trim_throttle set at 30 and min set to 12m/s and max to 18m/s. Into wind we a
Read more…I have several pairs of 3dr and clone 433MHz radios which were all working fine three days ago. They are all recognised using the standalone 3dr SiK radio software and when connected through that software the RSSI is ~180+ . The issue comes when I tr
Read more…I have suddenly developed major jitter on the extreme ends of the aileron output from my 3DR pixhawk. I have checked the servos and leads with a servo tester, furthermore the ailerons function normally when plugged directly into the RX, All other ch
Read more…I have just recently purchased a vufine for use when flying my drones. Sadly my eyesight is not what it once was and the MP display on the lens is difficult to read i.e. text sizes are too small for my eyes. None of the usual windows scaling changes
Read more…I am sure many of you have had the same issue but I am wondering what strategies you take to minimise this issue.
To illustrate. I have a flight with 312 images (taken with a sony a5100 from a skywalker 1900 and pixhawk fc). When using georef I get t
Read more…Apologies if this is the wrong place to post this question or if what I am asking seems a little silly.
I have a firefly6 tiltrotor airframe which came with modified MP software. I would like to switch to standard mission planner as I have been using
Read more…Dear all,
Apologies this is probably a dumb question but I have not done this before.
I am trying to setup my skywalker X6 with pixhawk. The pixhawk is connected via sbus to my taranis receiver (X8R). Everything is working as intended in manual mode (
Read more…I sent the following message to gentles.ltd.uk concerning one of their RC camera triggers.
"I am considering a Sony A5000 camera for my fixed-wing UAV build which uses the 3DR Pixhawk autopilot system. The system is pre-programmed using Mission Plann
Read more…Dear all,
Probably being a little stupid but I can connect to the PIxhawk using mission planner and my TX controls calibrate without a problem so I assume the sbus connection from my RX to the Pixhawk is working fine (power going the other way is clea
Read more…Apologies if this has been asked before.
I am trying to setup a new pixhawk via Mission Planner 1.2.97 . I have a FrSky Taranis radio with the 8XR receiver and followed an online video to setup the flight modes.
The radio signal is recognised and cal
Read more…