Hi,
I am have problems with several items in the new Mission planner.
When I attempt to load new firmware I am getting verify errors reported from the APM 2.5 board.
When I connect an exsisting working APM 2.5 board the Mission planner reports:
(a) Bad
Read more…When using the Mission Planner to fly a task I monitor the HUD screen carefully.
I have just found out the RSSI reading on the HUD does not show the actual value of the RSSI when flying it only shows 99% or 0% when signal is lost. When I play b
Read more…Since I updated to 1.2.36 I can no longer down load data logs from the APM board.
The log screen does not show any any log entries, even though terminal setup log entry said logs were in flash memory.
If I load an older version of Mission Planner the f
Read more…Today I flew at a different site which had stronger wind than I have experienced before.
I had been flying 2.9.1 release for the last few days with out any problems. The flight today was going well I selected RTL the quad climbed to 15 meters and tu
Read more…We have just completed constructing a 3 meter electric powered UAV with an inverted " Vee Tail " rudder /elevator assembly, ailerons and flaps. We can program the V tail in the transmitter but have not see how to set up the APM1 for this function.
Read more…During a test fight I noted that the modes I had programmed in setup did not seem to operating correctly.
I have APM 2.22 installed in control board.
I had " Manual, Stability and RTL " set in the 3 position mode switch. the first 2 modes seemed to wo
Read more…I carried out a successful test flying session this morning.
I came home and downloaded the log files, but no ".kml" files were produced. I am sure they used to be created in the past.
I am using APM Mission Planner V 1.0.55
I tried to use the recreate
Read more…I tried to update to APM Mission Planner to version 1.0.50.
It now fails to start and wants to send a dump to MicroSoft
I reloaded version V1.0.46 which was working before, and that to fail to start with the same message.
I have tried to install latest
Read more…When loading firmware from APM planner where is the source code
The terminal shows the code as AC.0.37 beta.
But the latest code I can find is AC.0.36 beta in the source file
Read more…
I have been flying successfully on AC 2.0.33 without any major problems
I thought it was time to try the latest version. I complied and loaded Version AC 2.0.36 then configured in CLI all seemed to work OK.
Took the QUAD to the flying field for testi
Read more…I have been testing the latest BETA software.
The the compass is behaving normally in all positions
Stabilzed mode is working well after retuning YAW setting.
Loiter is functioning a lot better than it was in Version 2.0.23 stable and tight position.
But
Read more…The Quad Copter documentation Manaual for configuring the mounting position of the magnetometer does not match the software supplied by the loaded files.
I could not find the line mention in any of the code???
So far I have not been able to make the ma
For my peace of mind does the ArduPilot auto navigation work in the south hemisphere. (My Eagle Tree had a problem in the southern
hemisphere when I first bought it)
I have been trying to get my ArduPilot going for 2 weeks .
Every thing works excep Read more…For my peace of mind does the ArduPilot auto navigation workin the south hemisphere. (My Eagle Tree had a problem in the southernhemisphere when I first bought it)
I have been trying to get my ArduPilot going for 2 weeks .
Every thing works except t
Read more…