Location
NA
About
Please tell us a bit about your UAV interest
Interested in RC Boats and autopilots
Hometown:
Christchurch
Activity Feed
"Sure. With Drone activities increasing in Antarctica and with a new base being built soon the planners are interested in supporting future science. With this in mind they want to build a specialist room to support Drone activities. This would be a…"
Strange title I know but I have been tasked with coming up with ideas for fitting out a Drone room at an Antarctic base. I have a bunch of ideas but wanted to see what the drone community would ask for (the sky's the limit!)
"Still hoping someone can answer this"
I have been flying waypoint missions with just four points all at 50m and then looping the mission with Do_Jump. The mission flies perfectly but the plane altimeter does not fly at 50m. The altimeter is reading 20-35m during the mission. When I try…
I have a Mobius mini I am using as fpv camera. I am using lawmate 1.2ghz tx/rx. I am getting signal to my immersionrc screen no worries. The problem is I cannot get a signal on my usb capture device. When I use my 5.8 GHz system no worries. All…
"Did you ever get this working? I have a camremote 2A and solo with accessory port wired in. I can get a RX to trigger the camera (SX260 with CHDK) but cannot get the solo to trigger the camera. "
"Not a lot of talk out there on this thread but in case you are wondering what has happened I have been talking with 3DR and sent them my wiring setup and they are sending me new minimOSDs. Hopefully these ones will be all good."
"Update
I got the usbasp cable. I looked at videos on how to upload bootloader and it seemed to work. I then managed to get the hex file for ArduOSD to upload. But here is where my success ended. As soon as I click the done box for the upload it…"
I got the usbasp cable. I looked at videos on how to upload bootloader and it seemed to work. I then managed to get the hex file for ArduOSD to upload. But here is where my success ended. As soon as I click the done box for the upload it…"
I have two MinimOSD boards purchased from 3DR that no longer talk to ArduOSD (failed to talk to bootlogger issue). While I found links to fix this issue, it is no help if each time I plug it into Pixhawk it works once then bricks again. Below is…
