Hello, the following picture shows the wires of the FMA sensors as following:
Ground, V+, Analog 1, Analog 0, (XY-sensor) Ground, V+, Analog 2, Unused (z-sensor)
On my red shield the names are: Ground, 5V, A3, A2, A1
The grounds of both sensors are
Hello,
i built the plane up (a old twinstar) and everything is set up so far. (Airspeedtube, Gps, Z-Sensor, XY-Senosr, firmware loaded)
The gps a Locosys LS20031 seems not to work, the leds on the gps himself just start lightning when i connect the Us
Hello,
i have read the manual but cannot find out how to connect a reciver to the board.
I see there are connectors on the board named: in 1,2,3,4 and out 1,2,3,4
There is also an CTRL on the side of the in 1,2,3,4
The reciver recives the signal and has
Hello, i have the seen there is a new complete manual for the arduPilot out. I have started to build the board and shield with the old manuals, now i have made everything like in the new one.My question is where do i put the 5 pin FMA sensor cable i
Read more…Hi, i have recived my ardupilot hardware today.I have looked on the homepage but i can not find a instruction how to complete the construction (where to solder the gps, the usb interface the shield, servos ec.) I found a instruction how to solder the
Read more…Hi, i am completly new here an i wanted a stabilized Return to launch system with gps, so i ordered the following from sparkfun:GPS-00574 Interface Cable for EM401 and EM406PRT-00743 Break Away Female Headers - Swiss Machine PinPRT-00117 Break Away H
Read more…